User manual MAXTOR CHEETAH 36LP INSTALLATION

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual MAXTOR CHEETAH 36LP. We hope that this MAXTOR CHEETAH 36LP user guide will be useful to you.

Lastmanuals help download the user guide MAXTOR CHEETAH 36LP.

Download

Manual abstract: user guide MAXTOR CHEETAH 36LPINSTALLATION

Detailed instructions for use are in the User's Guide.

 [. . . ] · Always use forced-air ventilation when operating the drive. · Use caution when troubleshooting a unit that has voltages present. · Do not disassemble the drive; doing so voids the warranty. · Return the entire drive for depot service if any part is defective.  [. . . ] · If you have an LC or LCV model drive,  the host normally sets the ID over the I/O interface,  so you don't need to worry about this step. 

Drive with HDA up,  PCB down,  viewed from front

J2 Pin 1

Pin 1

low level format,  do not abort the format as this is likely to make the drive inoperable. A low level format,  with verify turned on,  will typically take two hours. Protect against power failure or other power interruptions during the format. Boot the system from a system floppy,  CD,  or from a previously installed hard disc drive if there is one. Formatting a drive erases all user data. Be sure that you understand this principle before formatting any hard disc drive. It is not necessary to format a drive that previously has been used to store data,  unless your intention is to erase all user data. Seagate is not responsible for lost user data. Cheetah disc drives are designed to operate with a variety of operating systems. Please refer to your system or SCSI controller manual for information about formatting and setting up the drive. Some quick desktop system notes are provided below. Set the drive type in CMOS to "Zero, " "None, " or "No hard drive installed. " Use FDISK. EXE and FORMAT. EXE. Systems using Windows 98 or later can create one single partition (drive letter) on the drive. Use a third-party drive utility (most revisions of Apple's HD Setup utility only work with drives having special Apple firmware). 

HDA

Reserved Positions Delay Motor Start option (valid only if the Enable Motor Start jumper is not connected) Disable the Delay Motor Start option. Motor start delay equal to the SCSI ID multiplied by 12 seconds. (default)

J6
Reserved LR E EA A A A DS32 10

Reserved
11

Remote LED

Motor Start option
12

CATH

Shipped with cover installed. Do not install jumpers on these four positions. J6 Jumper Drive Front J6

Disable motor start (default). The drive starts according to the Delay Motor Start option. The drive waits for the Start Unit command from the host before starting the spindle motor. Write Protect option Write protect = Off (enables writing). 

(default)

(default)

Pin 1 End

Write protect = On (disables writing). Parity Check option Enable parity check of SCSI bus.  [. . . ] Seagate assumes no responsibility for data lost during shipping or service. Shipping drive in an unapproved container voids the warranty. Pack the drive with original box and packing materials. This prevents electrical and physical damage in transit. 

c. 

cables are required.  [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE MAXTOR CHEETAH 36LP

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual MAXTOR CHEETAH 36LP will begin.