User manual MAXTOR MEDALIST 6540

[. . . ] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Medalist 6540 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Medalist 5130 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Medalist 3220 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Ultra ATA Interface Drives . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] All measurements are generally consistent with ISO document 7779. Sound power measurements are taken under essentially free-field conditions over a reflecting plane. For all tests, the drive is oriented with the cover facing upward. Typical sound power (bels) 3. 7 4. 4 Maximum sound power (bels) 4. 1 4. 7 Mode Idle Read/Write 1. 10 Electromagnetic susceptibility The drive operates without errors when subjected to the following: Radiated noise Electrostatic discharge* Magnetic field strength 3 volt/meter, 30 Hz to 500 MHz 10 KVolts 5 Gauss * Electrostatic discharge susceptibility is measured with the drive mounted in a representative computer system (mounted to a ground plane with earth grounding). Discharges are applied to the bezel or other external surfaces on the ground plane. 1. 11 Reliability Nonrecoverable read errors Mean time between failures 1 per 1014 bits read, max 300, 000 power-on hours (nominal power, 25°C ambient temperature) 40, 000 cycles (at nominal voltage and temperature, with 60 cycles per hour and a 40% duty cycle) None required Contact start-stop cycles Preventive maintenance Medalist 6540, 5130 and 3220 Product Manual, Rev. A 15 1. 12 Agency certification 1. 12. 1 Safety certification The drives are recognized in accordance with UL 1950 and CSA C22. 2 (950) and meet all applicable sections of IEC950 and EN 60950 as tested by TUV North America. 1. 12. 2 Electromagnetic Compatibility Hard drives that display the CE marking comply with European Union requirements specified in Electromagnetic Compatibility Directives. Testing is performed to standards EN50082-1 and EN55022-B. Seagate uses an independent laboratory to confirm compliance with the EC directives specified in the previous paragraph. Drives are tested in representative end-user systems. Although CE-marked Seagate drives comply with the directives when used in the test systems, we cannot guarantee that all systems will comply with the directives. The drive is designed for operation inside a properly designed enclosure, with properly shielded I/O cable (if necessary) and terminators on all unused I/O ports. Computer manufacturers and system integrators should confirm EMC compliance and provide CE marking for their products. 1. 12. 3 FCC verification These drives are intended to be contained solely within a personal computer or similar enclosure (not attached as an external device). As such, each drive is considered to be a subassembly even when it is individually marketed to the customer. As a subassembly, no Federal Communications Commission verification or certification of the device is required. has tested this device in enclosures as described above to ensure that the total assembly (enclosure, disc drive, motherboard, power supply, etc. ) does comply with the limits for a Class B computing device, pursuant to Subpart J, Part 15 of the FCC rules. Operation with noncertified assemblies is likely to result in interference to radio and television reception. This equipment generates and uses radio frequency energy and if not installed and used in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception. 16 Medalist 6540, 5130 and 3220 Product Manual, Rev. A This equipment is designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television, which can be determined by turning the equipment on and off, you are encouraged to try one or more of the following corrective measures: · Reorient the receiving antenna. · Move the device to one side or the other of the radio or TV. · Move the device farther away from the radio or TV. [. . . ] Word Description Configuration information: · Bit 15: 0 = ATA; 1 = ATAPI · Bit 7: removable media · Bit 6: removable controller · Bit 0: reserved Number of logical cylinders: 13, 446 (ST36540A) 10, 585 (ST35130A) 6, 253 (ST33220A) ATA-reserved Number of logical heads: 15 (ST36540A, ST35130A) 16 (ST33220A) Retired Retired Number of logical sectors per logical track: 63 Retired Contents 0 0C5AH 3486H (ST36540A) 2959H (ST35130A) 186DH (ST33220A) 0000H 000FH (ST36540A) (ST35130A) 1 2 3 0010H (ST33220A) 0000H 0000H 003FH 0000H 4 5 6 7­9 continued 26 Medalist 6540, 5130 and 3220 Product Manual, Rev. A continued from previous page Word 10­19 20 21 22 Description Serial number: (20 ASCII characters, 0000H = none) Retired Retired Obsolete Contents ASCII 0000H 0000H 0000H Firmware revision (8 ASCII character 23­26 string, padded with blanks to end of string) Drive model number: 27­46 (40 ASCII characters, padded with blanks to end of string) (Bits 7­0) Maximum sectors per interrupt on Read Multiple and Write Multiple (64) Reserved Standard Standby timer, IORDY supported and may be disabled ATA-reserved PIO data-transfer cycle timing mode Retired Words 54­58, 64­70 and 88 are valid Number of current logical cylinders Number of current logical heads Number of current logical sectors per logical track x. xx ST36540A ST35130A or ST33220A 47 48 49 50 51 52 53 54 55 56 8020H 0000H 2F00H 0000H 0200H 0200H 0007H xxxxH xxxxH xxxxH xxxxH xxxxH 57­58 Current capacity in sectors 59 Number of sectors transferred during a Read Multiple or Write Multiple command Medalist 6540, 5130 and 3220 Product Manual, Rev. A Word Description Total number of user-addressable LBA sectors available: 60­61 12, 706, 470 (ST36540A) 10, 002, 825 (ST35130A) 6, 303, 024 (ST33220A) Retired Multiword DMA active and modes supported (see note following this table) Advanced PIO modes supported (modes 3 and 4 supported) Minimum multiword DMA transfer cycle time per word (120 nsec) Recommended multiword DMA transfer cycle time per word (120 nsec) Minimum PIO cycle time without IORDY flow control (240 nsec) Minimum PIO cycle time with IORDY flow control (120 nsec) Contents E2A6H 00C1H (ST36540A) 27 A189H 0098H (ST35130A) 2D30H 0060H (ST33220A) 62 63 64 65 66 67 68 0000H xx07H 0003H 0078H 0078H 00F0H 0078H 0000H 0000H 0000H 001EH 0000H 3069H 4001H 4000H 30xxH 0001H 4000H 69­74 ATA-reserved 75 Queue depth 76­79 ATA-reserved 80 81 82 83 84 85 86 87 continued Major version number Minor version number Command sets supported Command sets supported Command sets support extension Command sets enabled Command sets enabled Command sets enable extension 28 Medalist 6540, 5130 and 3220 Product Manual, Rev. A continued from previous page Word 88 89 90 Description Ultra DMA support and current mode (see note following this table) Security erase time Enhanced security erase time Contents 0x07H 0000H 0000H 0000H 0000H 91­127 ATA-reserved 128 Security status 129­159 Seagate-reserved 160­255 ATA-reserved xxxxH 0000H Note. [. . . ]