User manual MAXTOR ST31200W VOLUME 1

[. . . ] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . HAWK 1LP Family: ST31200W/WD/WC ST3620W . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Product Manual, Volume 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . HAWK 1LP Family: ST31200W/WD/WC ST3620W . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Product Manual, Volume 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . © 1995 Seagate Technology, Inc. [. . . ] The limits of shock and vibration defined within this document are specified with the drive mounted by any of the four methods shown in Figure 7. 4. 4-1. Operating The drive, as installed for normal operation, shall operate error free while subjected to intermittent shock not exceeding 10 g's at a maximum duration of 11 ms (half sinewave). Shock may be applied in the X, Y, or Z axis. Nonoperating The limits of nonoperating shock shall apply to all conditions of handling and transportation. This includes both isolated drives and integrated drives. The drive subjected to nonrepetitive shock not exceeding 75 g's at a maximum duration of 11 ms (half sinewave) shall not exhibit device damage or performance degradation. Shock may be applied in the X, Y, or Z axis. Packaged The drive as packaged in a single or multiple drive pack of gross weight 20 pounds (8. 95 kg) or less by Seagate for general freight shipment shall withstand drop test from heights listed below against a concrete floor or equivalent. For additional details refer to specifications 30190-001 (under 100 lbs) or 30191-001 (over 100 lbs). Package Size 600 - 1800 in3 (9, 832 - 29, 502 cm3) >1800 in3 (>29, 502 cm3) Drop Height 48 in (121 cm) 42 in (106 cm) Product Manual - Hawk 1LP Family (Wide bus) SCSI-2 (Volume 1), Rev. A 25 _____________________________________________________________________________________ B A E A1 D C D1 C1 SE AG AT E Z Y X Figure 7. 4. 4-1. Recommended mounting SE AG AT E B1 B1 A1 B A Z X Y E1 E1 D1 C1 E D C 26 Product Manual - Hawk 1LP Family (Wide bus) SCSI-2 (Volume 1), Rev. A _____________________________________________________________________________________ 7. 4. 4. 2 Vibration a. Operating The drive, as installed for normal operation, shall operate error free while subjected to continuous vibration not exceeding 5-22 Hz @ 0. 040 inches (1. 03 mm) displacement peak-to-peak 22-400 Hz @ 0. 5 g Vibration may be applied in the X, Y, or Z axis. Nonoperating The limits of nonoperating vibration shall apply to all conditions of handling and transportation. This includes both isolated drives and integrated drives. The drive shall not incur physical damage or degraded performance as a result of continuous vibration not exceeding 5-22 Hz @ 0. 081 inches (2. 05 mm) displacement peak-to-peak 22-400 Hz @ 2. 00 g's Vibration may be applied in the X, Y, or Z axis. 7. 4. 5 Air cleanliness The drive is designed to operate in a typical office environment with minimal environmental control. 7. 5 7. 5. 1 Electromagnetic compatibility Electromagnetic susceptibility As a component assembly, the drive is not required to meet any susceptibility performance requirements. It is the responsibility of the system integrator to perform those tests required to ensure that equipment operating in the same system as the drive does not adversely affect the performance of the drive. See section 6. 1. 2, and see Table 7. 2-1, DC Power Requirements. Product Manual - Hawk 1LP Family (Wide bus) SCSI-2 (Volume 1), Rev. A 27 ______________________________________________________________________________________ 7. 6 Mechanical specifications The following nominal dimensions are exclusive of the decorative front panel accessory. [. . . ] SeaFAX number: United States 408/438-2620 England 44-62-847-7080 You can use a touch-tone telephone to access Seagate's automated FAX delivery system and select technical support information by return FAX. This service is available 24 hours a day, 7 days a week. Seagate Technical Support FAX: 408/438-8137 You can FAX specific questions or comments to Seagate technical support specialists 24 hours daily. SeaFone telephone number: 408/438-8222 The enhanced phone system provides recorded technical information on selected Seagate products while you are on hold. [. . . ]