User manual MAXTOR ST31275A QUICK INSTALLATION

[. . . ] · Save your Seagate packing materials for future use. Using any other container or packing material voids your drive warranty and may damage your drive. LIMITED WARRANTY STATEMENT Seagate warrants that your Seagate disc drive will be free from defects in material and workmanship and will perform to Seagate's applicable specifications for Seagate's threeyear warranty period. The warranty period will be calculated from the date of original purchase. Seagate will replace, at no charge, any drive that does not meet our warranty. [. . . ] SeaFONE TM , SeaTDD TM , SeaBOARD TM and SeaFAX TM are trademarks of Seagate Technology, Inc. Other product names are registered trademarks or trademarks of their owners. No part of this publication may be reproduced in any form without written permission from Seagate Technology, Inc. C, April 1996 Compuserve Forum: Internet Connections: USA USA Germany Singapore Australia 408-438-8771 49-89-140-9331 65-292-6973 61-2-756-2359 408-438-2620 SeaTDD: Use a telecommunications device for the deaf (TDD) to exchange messages with a technical support specialist. 408/438-5382 SeaFAX: Use a touch-tone telephone to access Seagate's automated FAX system to receive technical information by return FAX. This service is available 24 hours daily. SeaBOARD: Use a modem to contact the Seagate computer bulletin board, which supports communications up to 9, 600 baud (8-N-1). SeaBOARD is available 24 hours daily. Please read this installation guide before you install your new drive. If you are not familiar with the procedures outlined here, have a qualified computer technician perform the drive installation. If you need assistance installing this drive, first consult your dealer, who can help you with system conflicts and other technical issues. If you need additional assistance, use one of the services listed below, or call the Seagate support line at 1-800-426-6637. Technical support services France England Thailand Korea England 44-1-62-847-7080 Type GO SEAGATE http://www. seagate. com ftp://ftp. seagate. com (+33 1) 48 25 35 95 44-1-62-847-8011 662-531-8111 82-2-556-7294 INSTALLATION GUIDE NSTALLA Q UICK INSTALLATION GUIDE CFS270A CFS425A ST3541A ST3635A ST3851A ST3851A1 ST31081A ST31275A ST31621A Hard ATA/IDE Har d Drives INSTALLATION Steps: 1. Turn off the computer and all attached peripheral equipment, such as printers and monitors. Remove the screws attaching the computer's cover, and remove the cover from the system. Remove the drive from the ESD (Electro Static Discharge) bag, carefully placing the drive on your work surface. Configure the disk drive jumpers as necessary. Refer to master/slave jumper table below for more details. Connect the cables; align the colored striped edge of the interface cable to pin 1 of the drive interface connector. Partially insert the drive into the drive bay. Select an unused power connector from the power supply and connect it to the drive. [. . . ] Insure that your Master/Slave (C/D) jumper is properly configured. b) If the AT BIOS supports a user definable drive type, program the BIOS to the parameters in the table below. NOTE: Precomp should be set to zero (0) for all drives and the Landing Zone should be set to the number of cylinders. c) If the AT BIOS does not support user definable drive type select a drive type that is close to the drives parameters, but do not exceed the drives formatted capacity. [. . . ]