User manual MAXTOR ST32107N QUICK INSTALLATION

[. . . ] · Set the drive down only on a flat, padded, non-static surface. · This drive is susceptible to damage from electrostatic discharge. Before handling the drive, ground yourself by touching the grounded chassis of your computer. For optimum protection, wear a grounded antistatic wrist strap. [. . . ] IN NO EVENT WILL SEAGATE'S LIABILITY OF ANY KIND INCLUDE ANY LOST PROFITS, LOSS OF USE, LOSS OF DATA, OR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF SEAGATE HAS KNOWLEDGE OF THE POSSIBILITY OF THE POTENTIAL LOSS OR DAMAGE. Some states do not allow for the exclusion or limitation of liability for consequential or incidental damages, as such, the above limitations may not apply to you. Documentation: Seagate Technology makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Seagate Technology shall not be liable for errors contained herein or for incidental consequential damages in connection with the furnishing, performance, or use of this material. Seagate reserves the right to change, without notice, product offerings or specifications. Seagate®, Seagate Technology® and the Seagate logo are registered trademarks of Seagate Technology, Inc. SeaFONE TM , SeaTDD TM , SeaBOARD TM and SeaFAX TM are trademarks of Seagate Technology, Inc. Other product names are registered trademarks or trademarks of their owners. No part of this publication may be reproduced in any form without written permission from Seagate Technology, Inc. B Compuserve Forum: Internet Connections: USA USA Germany Singapore Australia 408-438-8771 49-89-140-9331 65-292-6973 61-2-756-2359 408-438-2620 SeaTDD: Use a telecommunications device for the deaf (TDD) to exchange messages with a technical support specialist. 408/438-5382 SeaFAX: Use a touch-tone telephone to access Seagate's automated FAX system to receive technical information by return FAX. This service is available 24 hours daily. SeaBOARD: Use a modem to contact the Seagate computer bulletin board, which supports communications up to 9, 600 baud (8-N-1). Please read this installation guide before you install your new drive. If you are not familiar with the procedures outlined here, have a qualified computer technician perform the drive installation. If you need assistance installing this drive, first consult your dealer, who can help you with system conflicts and other technical issues. If you need additional assistance, use one of the services listed below, or call the Seagate support line at 1-800-426-6637. Technical support services France England Thailand Korea England 44-1-62-847-7080 http://www. seagate. com ftp://ftp. seagate. com type GO SEAGATE (+33 1) 48 25 35 95 44-1-62-847-8011 662-531-8111 82-2-556-7294 INSTALLATION GUIDE NSTALLA Q UICK INSTALLATION GUIDE ST31080N / WC ST32105N / W / WC ST32107N / W/ WC / NV ST14207N / W / WC / NV SCSI Hard Drives INSTALLATION Steps: 1. Turn off the computer and all attached peripheral equipment, such as printers and monitors. Disconnect the AC power cable from the computer. Remove the screws attaching the computer's cover, and remove the cover from the system. [. . . ] Damage to the drive's circuit board could result. The maximum insertion in bottom holes is . 25", the maximum insertion for side holes is . 125". SCSI Disk Drive Models Total Blocks 2, 110, 812 4, 194, 304 4, 194, 304 8, 388, 608 Tables LED D D D D Jumper Table a b, c b, c b, c Notes 2 1, 2 1, 2 1, 2 Warranty (Years) 5 5 5 5 ST31080N/WC ST32105N/W/WC ST32107N/W/WC/NV ST14207N/W/WC/NV Jumper Table a b c ST31080N/WC ID0 ID2 Disable Spin HDA Connector LED Driver Spin Sync E1, Enable Term Power SCSI Terminators Remove in all but the last drive in the chain ID0 E1 OE1 ID1 E2 OE2 ID2 E3 OE3 N/A N/A N/A J6 J3 SCSI ID 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 J4 OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT OUT IN IN OUT OUT IN IN OUT OUT IN IN OUT OUT IN IN OUT OUT OUT OUT IN IN IN IN OUT OUT OUT OUT IN IN IN IN OUT OUT OUT OUT OUT OUT OUT OUT IN IN IN IN IN IN IN IN J2, Pin 1 50-Pin SCSI Interface J5, Pin 1 4-Pin Power Connector ID0 1 23 4 ID1 ID 2 Disable Spin ST32105/32107/14207/N/W/WC/NV LED Driver OE1 OE3 J7 OE5, LED Driver Spin Sync E8, Enable Term Power In/Out SCSI Terminators Remove in all but the last drive in the chain HDA Connector LED Configuration Table Letter Connector LED+ B J-1 Pin 3 C J-5 Pin 3 D J-3 Pin 3 E J-7 Pin 1 Notes Note 1 Note 2 Note 3 Note 4 * LEDPin 4 Pin 4 Pin 4 Pin 2 J3 E1. . E3 E4 Reserved E5 (Disable Spin) J2, Pin 1 50-Pin SCSI Interface J4, Pin 1 4-Pin Power Connector 23 4 "W" drives use Jumper Table c, e "WC" drives have no jumpers Parity is enabled by default. Most SCSI host adapters are compatible with Seagate drives. Software drivers and installation instructions are provided with the host adapter. [. . . ]