User manual MAXTOR ST52160N INSTALLATION

[. . . ] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Medalist Pro 2160N (ST52160N) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SCSI Hard Drive . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installation Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -2 Medalist Pro 2160N, Rev. B © 1997­1999 Seagate Technology, Inc. [. . . ] Options jumper settings The options jumper block allows you to configure your drive for several additional configuration options. The drawing in Figure 7 shows how to place jumpers to enable each optional feature. A brief description of each option is included. See "SCSI termination" on page 5. Listen carefully to determine whether the drive motor is spinning. Also, the drive-activity LED should flash when the power is turned on. If the LED stays on after power-on, make sure the interface cable is properly connected and that no other device on the cable is using the same SCSI ID. Check the drive type settings in the system setup program. The CMOS drive-type must be set to none, zero or not installed. Verify your SCSI host adapter configuration. Make sure your host adapter is not using an I/O address or interrupt that conflicts with other devices in your system. Refer to your host adapter's guide for assistance. Host adapters have a diagnostic utility that can help you determine whether such conflicts exist. Each time you add a new device to your computer, make sure your computer's internal power supply can support the total power demand. If necessary, consult your dealer for a new power supply. Before you use someone else's diskette in your system for the first time, scan the diskette for viruses. tem, try disconnecting all drives except the new one. Then configure and install only the new drive. This test helps determine whether a compatibility problem exists. If you are installing the drive in a network, verify that the drive works with DOS. · Isolate the drive. If there is more than one drive in your sys- Medalist Pro 2160N, Rev. B 19 If the drive works with DOS, refer to your Netware user's guide for assistance. Additional troubleshooting If you have performed the preceding basic checks but the problem persists, follow these guidelines for troubleshooting specific cases: The screen remains blank when you power up the system. [. . . ] Figure 8 shows how a drive fits in an approved single-pack box, including the packing materials. Back up the data on your drive before shipping the drive. Seagate assumes no responsibility for data lost during shipping or drive repair. Foam Antistatic bag Drive Foam Foam Figure 8. Seagate drive and approved packing materials Medalist Pro 2160N, Rev. [. . . ]