User manual MAYTAG MDE9601

[. . . ] Operating Instructions Tumble dryer Dear Maytag customer, Thank you for choosing this quality product from Scandinavia, made in Vara, Sweden. We want you to feel assured that the inside of your new machine is just as good as the outside and that the ethics and standards that went into the production of this machine are just as high as the quality and performance that you will receive from it. We hope that this product will give you many years of pleasure. To get the most out of your new machine, we recommend that you read the Use & Care Guide before using the machine. MDE9601 Contents Contents 2 Before using your machine for the first time 3 3 Do not tumble-dry Safety instructions 4 General 4 Installation 4 Safety 4 Stopping a programme 4 Packing material 4 Disposal 4 Child safety 5 General 5 Parts of the tumble dryer 6 Front panel 7 Options buttons 7 Advice and tips before you tumble-dry 8 Has it been spun? [. . . ] Grasp the filter handle and pull it towards you. Open the filter and remove the fluff by hand. Fold the filter up and re-insert it into its holder. The filter may need to be cleaned if limescale deposits occur, see "Care and cleaning" chapter. 6 Press the Start button Drying time remaining An estimate of the remaining drying time will be shown in the display within 2 minutes of the drying programme starting. For example, 1:35 means that approximately 1 hour and 35 minutes remain until the load achieves the selected level of dryness. If the Anti-crease option has been selected, the drum will rotate every minute for two hours after cooling. If you want to stop or change a programme Press and hold the Start/Stop button for three seconds. The red field next to the button goes out. The programme is not affected if the programme selector is changed after the programme starts. To load or remove washing If you want to load or remove washing once you have started the machine, open the door and the machine will stop automatically. Load more washing, close the door and press the Start/Stop button. 2 1 10 Switch off the main power switch. Remove the clothes, and close the door to prevent small children from climbing into the machine. 8 Once drying has finished 11 Consumption values For the consumption values given below, the following prerequisites apply: Temperature of intake air: 20 °C. Before tumble-drying, cotton fabrics are spun at 800 and 1600 rpm (long spin). Before tumble-drying, other fabrics (crease-resistant and acrylic) are spun at 800 rpm (short spin). Dry Extra Dry Programme Cotton, linen Cotton, linen Cotton, linen Material Normal Normal Normal Normal Normal Normal Low Energy Programme consumption Max. min. ) Temperature (kg) 800 rpm 1600 rpm 800 rpm 1600 rpm 6. 0 6. 0 3. 0 6. 0 3. 0 3. 0 6. 0 4. 1 3. 7 1. 6 3. 5 1. 5 1. 8 2. 8 3. 2 2. 9 2. 6 1. 9 130 120 110 50 55 85 50 105 90 85 55 - Normal Dry Normal Dry Normal Dry Iron Dry Dry Crease-resistant, polyester/cotton Crease-resistant, polyester/cotton Acrylic, rayon, acetate Cotton, linen 12 Care and cleaning Cleaning the fluff filter The fluff filter must be cleaned after each load. If you have very hard water, this can cause limescale deposits in the fluff filter. Check for any limescale deposits when cleaning the fluff filter and, if necessary, wash down the filter by hand. Grasp the filter handle and pull it towards you. Pull the filter out of its holder. Cleaning the outside of the machine Clean the outside of the machine and the programme panel with a mild cleaner. Do not use any solvents, as these can damage the machine. Do not hose down or spray the machine with water. Do not allow dust to accumulate around the machine. [. . . ] Press the Start/Stop button 5 times (within 10 seconds). Adjust the programme selector so that the Extra Dry light comes on (10 o'clock). Press the Start/Stop button to store the setting. If you want to reset the machine to a 16A connection: 1. [. . . ]