User manual MAYTAG MZD2666SS INSTALL

[. . . ] Installation Location · Do not install refrigerator near oven, radiator or other heat source. If not possible, shield refrigerator with cabinet material. · Do not install where temperature falls below 55° F (13° C) or rises above 110° F (43° C). Malfunction may occur at this temperature. [. . . ] · Check with level to verify 1/4" tilt to the back for proper door closure. · If refrigerator is aligned and stable, replace toe grille. · Align the toe grille mounting clips with the lower cabinet slots. · Push the toe grille firmly until it snaps into place. CAUTION To avoid property damage or possible injury, follow basic precautions, including the following: · Consult a plumber to connect 1/4" O. D. copper tubing to household plumbing to assure compliance with local codes and ordinances. · Confirm water pressure to water valve is between 35 and 100 pounds per square inch, 20 pounds per square inch without filter. · Do not use a self-piercing, or 3/16" saddle valve. Both reduce water flow and can become clogged over time, and may cause leaks if repair is attempted. · Tighten nuts by hand to prevent cross threading. Finish tightening nuts with pliers and wrenches. · Wait two to three hours before placing refrigerator into final position to check and correct any water leaks. · Verify the copper tubing under the sleeve is smooth and free from defects. Materials Needed: Connecting the Water Supply (select models) WARNING To reduce the risk of injury or death, follow basic precautions, including the following: · Read all instructions before installing ice maker. · Do not attempt installation if instructions are not understood or if they are beyond personal skill level. · Observe all local codes and ordinances. · Do not service ice maker unless specifically recommended in Use & Care Guide or published user-repair instructions. · Disconnect power to refrigerator before installing ice maker. · Water damage due to an improper water connection may cause mold/mildew growth. Clean up spills or leakage immediately! · 1/4" outer diameter flexible copper tubing · Shut-off valve (requires a 1/4" hole to be drilled into water supply line before valve attachment) · Adjustable wrench (2) · 1/4" hex nut driver Notes: · Use copper tubing only for installation. Plastic is less durable and can cause damage. · Add 8' to tubing length needed to reach water supply for creation of service loop. Create service loop with copper tubing (minimum 2' diameter). [. . . ] Align notches on back of handle with retaining clips on doors. Insert clips into notches and slide handle down until it contacts bottom trim. Replace top door trim and Phillips screws. Repeat instructions 1-3 to install other handle. [. . . ]