User manual MC CULLOCH B40B ELITE

[. . . ] A clearing saw, brushcutter or trimmer can be dangerous if used incorrectly or carelessly, and can cause serious or fatal injury to the operator or others. It is extremely important that you read and understand the contents of this operator’s manual. Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. Always wear: • • • A protective helmet where there is a risk of falling objects Approved hearing protection Approved eye protection 10000 Choke: Set the choke control in the choke position. [. . . ] Always start by filling half the amount of the petrol to be used. Mix (shake) the fuel mixture thoroughly before filling the machine’s fuel tank. Taking the following precautions, will lessen the risk of fire: Mix and pour fuel outdoors, where there are no sparks or flames. Do not smoke or place hot objects near fuel. Always shut off the engine before refuelling. Always stop the engine and let it cool for a few minutes before refuelling. When refuelling, open the fuel cap slowly so that any excess pressure is released gently. Tighten the fuel cap carefully after refuelling. € • • Do not mix more than one month’s supply of fuel at a time. If the machine is not used for some time the fuel tank should be emptied and cleaned. € • • • Always move the machine away from the refuelling area and source before starting. Always use a fuel container with an anti-spill valve. Wipe off the spillage and allow remaining fuel to evaporate. Contamination in the tank can cause operating problems. Ensure that the fuel is well mixed by shaking the container before filling the tank. english – 17 S1155295-26 , B40 B , BT ELITE 1. Fm Page 18 Tuesday, December 18, 2012 7:09 AM STARTING AND STOPPING Check before starting trimmer guard if they have been exposed to impact or are cracked. € Check the blade to ensure that no cracks have formed at the bottom of the teeth or by the centre hole. The most common reason why cracks are formed is that sharp corners have been formed at the bottom of the teeth while sharpening or that the blade has been used with dull teeth. € • • Check that the support flange is not cracked due to fatigue or due to being tightened too much. discard the support flange if it is cracked. Never use the machine without a guard nor with a defective guard. [. . . ] Begynd med at save høje stubbe i staudens yderdel af for at undgå, at saven sætter sig fast. 1 Brændstoffilter 1 Hvis motoren kører tør for brændstof, skal tankdækslet og brændstoffilteret kontrolleres for blokering. Luftfilter Vinkelgear Luftfilteret skal rengøres regelmæssigt for støv og snavs for at undgå: • • • • • Karburatorforstyrrelser Startproblemer Dårlig effekt Unødvendig slitage på motorens dele. 2: Rapporterede data for ækvivalent lydtryksniveau for maskinen har en typisk statistisk spredning (standardafvigelse) på 1 dB (A). [. . . ]