User manual MC CULLOCH M185107TC

[. . . ] M185-107TC Euro Please read these instructions carefully and make sure you understand them before using this machine. 3 19 37 45 47 60 92 95 We reserve the right to make changes without prior notice. Safe Operation Practices for Ride-On Mowers III. Be familiar with the controls and the proper use of the equipment. [. . . ] • Slowly depress reverse drive pedal to begin movement. € When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position. Cutting tips • • • • Clear the lawn from stones and other objects which can be thrown away by the blades. localize and mark stones and other fixed objects to avoid collision. Begin with a high cutting height and reduce until the required cutting result is obtained. The cutting result is best with high engine speed (blades rotate quickly) and low gear (machine goes slowly). If the grass is not too long and thick the drive speed can be increased by selecting a higher gear or increasing the motor speed, without affecting the cutting result. The best lawn is achieved if the grass is cut often. Cutting becomes more even and the cut grass is more evenly distributed over the surface. Total time taken is not greater, since higher drive speed can be selected without affecting the cutting results. The cutting results will be worse since the wheels will sink into the soft lawn. Spray the cutting unit with water underneath after use. To turn off the alarm disengage the attachment clutch control. • Position tractor in location you wish to dump bagger. € Ensure that the transaxle is in the neutral position. Pull handle forward to raise bagger and dump clippings. € To continue mowing, move unit forward to ensure bagger is completely lowered and in proper operating position which will allow mower to operate. 55 5 To convert mower: (Converting to mulching or rear discharging will require the purchase of these accessories. ) To mulching Place deck into the high cut position. remove bagger or optional rear discharge deflector. Insert plug assembly through back plate and into the mower deck chute adaptor. € Retain the plug assembly by connecting the two straps into the holes provided on the bagger support arms. [. . . ] € Move the tractor to a dry area, preferably a concrete or paved area. Place the attachment clutch control in the “Engaged” position to remove excess water and to help dry before putting the tractor away. WARNING: A broken or missing washout fitting could expose you or others to thrown objects from contact with the blade. Replace broken or missing washout fitting immediately, prior to using mower again. [. . . ]