User manual MC CULLOCH ROTOVATOR MRT6

[. . . ] MRT6 Instruction manual Please read these instructions carefully and make sure you understand them before using this machine. 3 7 14 36 46 55 58 We reserve the right to make changes without prior notice. Be familiar with the controls and the proper use of the equipment; Never allow children or people unfamiliar with these instructions to use the machine. Local regulations can restrict the age of the operator. [. . . ] Place choke lever on engine halfway between "CHOKE" and "RUN" position (fig. 6) and then move to "RUN" position as engine warms up. 8) halfway between "FAST" and "STOP" position for a few minutes to warm up. Keep drive control lever in "disengaged" position when starting the engine (fig. In order to idle smoothly, a new engine may require 3 to 5 minutes runnig time above slow idle speed. Idle speed has been adjusted to be correct after this break-in period. Always release drive control lever before moving shift lever into another position. To start tiller movement, push down on the drive control release and squeeze the drive control lever (fig. Don't back yourself into a solid obstruction such as a tree, fence, etc. To stop engine, move throttle control (fig. Lift handle to raise tines out of the ground (fig. Swing the handle in the opposite direction you wish to turn, being careful to keep feet and legs away from the tines. When you have completed your turn-around, lower the handle. place shift lever indicator in ( ) (tilling) position and move throttle control to desired speed. To begin tilling, push down on the drive control release and hold drive control lever against the handle. Figure 10 de pt h_ st 1 e_ ak Inset B 18 12 13 14 15 16 Inset C Outer side shields 19 The back of the outer side shields (fig. 9) are slotted so that they can be raised for deep tilling and lowered for shallow tilling to protect small plants from being buried. Lower the depth stake to its lowest position and insert the depth stake pin in the topmost hole. To start tiller movement, push down on the drive control release and squeeze the drive control lever (fig. Pull the depth stake up for increased tilling depth. To start tiller movement, push down on the drive control release and squeeze the drive control lever. For cultivating move throttle control to desired speed. [. . . ] Select handle height suitable for you and your tilling conditions. Handle height will change when tiller digs into the soil. Stop the engine and remove the spark plug wire and cover from the spark plug (fig. 6) before cleaning out the tines by hand. [. . . ]