User manual MC CULLOCH T22LS

[. . . ] Careless or incorrect use can result in serious or fatal injury to the operator or others. It is extremely important that you read and understand the contents of the operator’s manual. Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. Always wear: A protective helmet where there is a risk of falling objects • • Approved hearing protection Approved eye protection Ignition; choke: Set the choke control in the choke position. [. . . ] Contamination in the tank can cause operating problems. Ensure that the fuel is well mixed by shaking the container before filling the tank. The catalytic converter muffler gets very hot during and after use. Be aware of the fire hazard, especially when working near flammable substances and/ or vapours. € • • English – 13 STARTING AND STOPPING Check before starting Choke: Set the choke control in the choke position. € Check that the trimmer head and trimmer guard are not damaged or cracked. Replace the trimmer head or trimmer guard if they have been exposed to impact or are cracked. € • Never use the machine without a guard nor with a defective guard. All covers must be correctly fitted and undamaged before you start the machine. When the engine is started with the choke in choke position the cutting attachment will start to rotate immediately. Hold the body of the machine on the ground using your left hand (CAUTION!Grip the starter handle, slowly pull out the cord with your right hand until you feel some resistance (the starter pawls grip), now quickly and powerfully pull the cord. Never twist the starter cord around your hand. Repeat pulling the cord until the engine starts. Return choke control to run position and apply full throttle; the throttle will automatically disengage from the start setting. Do not pull the starter cord all the way out and do not let go of the starter handle when the cord is fully extended. The complete clutch cover and shaft must be fitted before the machine is started, otherwise the clutch can come loose and cause personal injury. Always move the machine away from the refuelling area and source before starting. Ensure the cutting attachment cannot come into contact with any object. Make sure no unauthorised persons are in the working area, otherwise there is a risk of serious personal injury. Stopping Stop the engine by switching off the ignition. Starting Primer bulb: Press the air purge repeatedly until fuel begins to fill the bulb. [. . . ] For lyddæmpere er det meget vigtigt, at instruktionerne for kontrol, vedligeholdelse og service overholdes. For at opnå en længere levetid for linen kan den lægges i vand et par døgn. Se anvisningerne til skæreudstyret for korrekt indføring af line og valg af korrekt diameter for line. Sørg for, at der ikke opholder sig uvedkommende inden for arbejdsområdet, ellers er der risiko for alvorlige personskader. [. . . ]