User manual MCCULLOCH 335 PARTS LIST 2000

[. . . ] Dear Customer, Thank you for purchasing a McCulloch product. With proper operation and maintenance, it will provide you with years of service. In order to make the best use of your investment, be CERTAIN to familiarize yourself with the contents of the ENTIRE user manual before attempting to operate and maintain your unit. Be sure to carefully follow the step-by-step instructions in this manual to start, operate and maintain your new product. [. . . ] Inspect extension power cord for loose or exposed wires and damaged insulation. if damaged , replace before using trimmer. DO NOT ABUSE CORD - Never carry trimmer by cord or pull cord to disconnect from outlet. Keep cord clear of operator and obstacles at all times. Do not expose cord to heated surfaces, oil or water. Do not pull cord around sharp edges, corners or close door on cord. For service information, contact the McCulloch Product Service Department listed on the back cover of this User Manual. RISK OF EYE INJURY - Always wear goggles or other suitable eye protection when operating your trimmer. Edging increases the risk of injury caused by flying debris. Always keep bystanders at a safe distance. DRESS PROPERLY - Always wear long pants, shoes and gloves. Align edging guide with mating grooves and push firmly in the direction shown until an audible snap is heard (Figure 3-1B). nOTE: Be certain that edging guide is oriented as shown. Once edging guide, motor housing and debris shield are mated the connection is permanent and cannot be removed without a special tool. Before tightening completely, adjust the assist handle height by sliding handle up or down tube. Push shaft locking button forward, and rotate handle assembly until an audible click is heard (Fig. Ensure the cord is NOT plugged into a receptacle before this procedure. Make a loop with 8 - 10 (20 - 25cm) of the end of the extension cord. Place the loop into the slot (A) under the rear handle and lock into place on the cord retainer as shown in Figure 5-1. connect the extension cord to the trimmer. Plug the extension cord into a receptacle ONLY when you are ready to operate the trimmer. With the unit configured as an edger, hold it so the motor is to your left side so that debris is thrown to the rear. [. . . ] To do so, push the head on and turn it clockwise until it locks. Remove the clear plastic line retaining ring. Remove any existing line from the spool. 065" replacement line measure off approximately 14' of line. [. . . ]