User manual MCCULLOCH CABRIO 433L

[. . . ] Electrolux Outdoor Products manufacture products for a number of well known brands under various registered patents, designs and trademarks in several countries. Electrolux Outdoor Products Italy MANUAL DO OPERADOR D WICHTIGE INFORMATION: Lesen Sie diese Hinweise zur Handha-bung des Gerts aufmerksam durch. Verwenden Sie es erst, wenn Sie sicher sind, da Sie alle Anweisungen verstanden haben und gut aufbewahren. P INFORMAES IMPORTANTES: Queira ler cuidadosamente estas instrues e tenha certeza de entend--las antes de usar a serra e guarde para consulta futura. MANUAL DE INSTRUCCIONES EXEIPIIO XEIPIMOE E INFORMACIN IMPORTANTE: Lea atentamente las instrucciones y asegrese de entenderlas antes de utilizar esta aparato. Conserve las instrucciones para la referencia en el futuro. GR HMANTIKE HPOOPIE: oxx v x ov v xvo v o v x u v u u v. The Electrolux Group. [. . . ] Before starting to work fit the harness. Adjust harness with the buckle so that the trimmer is well balanced on your right side and the blade or string head is parallel to the ground. Always maintain a firm foothold and a good balance while using the machine. Do not move backwards while you work as obstacles may not be visible. The fitting of the safety pole barrier is obligatory on units equipped with a delta shaped handle when used with a metal blade. The purpose of this safety pole barrier is to maintain a safe distance between the metal blade and the user under all normal or exceptional circumstances. 2) Harness ring (B) must never be moved from its original position to avoid unbalancing the unit. Front handles can be separately adjusted to make usage easier on units fitted with "U" shaped handles. 3) The following accessories can be assembled to your trimmer: a) blade, b) nylon string head. Do not attach any blade to a unit without proper installation of all required parts. Failure to use the proper parts can cause the blade to fly off and seriously injure the operator and/or bystanders. THE USE OF NON-ORIGINAL ACCESSORIES AND SPARE PARTS INCREASES THE RISK OF ACCIDENTS AND IN SUCH A CASE THE COMPANY IS NOT LIABLE FOR DAMAGE TO PEOPLE AND/OR THINGS. D. FUEL MIX Use only fuel recommended by this manual. This product is fitted with a 2-stroke engine and therefore requires a 2-stroke petrol and oil mix. Use leaded (4 Star) or unleaded petrol with a minimum octane rating of 90. In order to obtain a good fuel mix, put the oil into the container before the petrol. The use of sub-standard petrol or oil may reduce performance or reduce the life of certain components. Leaded Petrol If using leaded petrol, the correct fuel mix is achieved by either using 5% (20:1) of a well known brand of 2-stroke engine oil, or else 2. 5% (40:1) of special engine oil. Unleaded Petrol If using unleaded petrol, you must use a totally synthetic 2-stroke engine oil or branded 2-stroke engine oil. IMPORTANT Always shake the fuel mix container thoroughly before pouring any fuel mix. Fuel mix properties may deteriorate with time and should be used up within 2 months. We recommend that you prepare fuel mix according to your immediate requirements only. [. . . ] To adjust the idle speed, however, proceed as follows: With engine running and warm, slowly turn screw `I' or `T' clockwise until the engine runs smoothly with a consistent noise level but without making the chain or cutting head rotate. If the cutting attachment does move or the engine 9 A runs too fast, slowly turn screw `I' or `T' in an anticlockwise direction until the correct speed is obtained. Precise numerical engine speed settings are mentioned in the technical detail chart in the front of the owner's manual. NOTE: A) Direct drive trimmers: The cutting head will always rotate when engine is running. [. . . ]