User manual MCCULLOCH FB4052

[. . . ] Do not operate the log splitter while under the influence of drugs, alcohol, or any medication that could affect your ability to use it properly. Put the log splitter on a 60 - 75cm high, stable, flat, and level work bench where there is plenty of room for handling, and help the operator stay altert. Bolt the log splitter to the work surface if it tends to slip, walk, or slide. Keep your work area clean and well lighted. [. . . ] Be sure the extension cord is no longer than 10m and its section is no less than 2. 5mm2 to allow sufficient current flow to the motor. Avoid use of free and inadequately insulated connections. Connections must be made with protected material suitable for outdoor use. Unplug when not in use, before making adjustments, changing parts, cleaning, or working on the log splitter; Consult technical manual before servicing. This log splitter is a home use model. It is designed for operating under ambient temperatures between +5oC and 40oC and for installation at altitudes no more than 1000m above M. The surrounding humidity should less than 50% at 40oC. It can be stored or transported under ambient temperatures between -25°C and 55°C. Take used oil to an authorized collection point or follow the stipulations in the country where the log splitter is used. Do not discharge into drains, soil or water. Keep the log splitter clean for best and safest performance. Store the log splitter away from children and others not qualified to use it. 61 Lbs (43 kg) The diameter of the log is indicative - a small log can be difficult to split when it has knobs or a particularly tough fiber. On the other hand, it may not be difficult to split logs with regular fibers even if its diameter exceeds the max. Bolt the Support Leg to the Log Splitter, lift the log splitter by the handles at both ends and place it on a 60 - 75cm high, stable, flat and level work surface. Familiarize yourself with the controls and features of this log splitter in the illustrations. Max pressure was set before the log splitter ex work and the max pressure limiting screw is sealed with glue to ensure the log splitter works under pressure no more than 4 tons. The setting was done by qualified mechanic with professional instruments. Unauthorized resetting will cause the hydraulic pump fail to output enough splitting pressure or RESULT IN SERIOUS INJURY AS WELL AS DAMAGE TO THE MACHINE . Before operating the log splitter, the Bleed Screw should be loosened by some rotations until air can go in and out of the oil tank smoothly. Air flow thru the Bleed Screw hole should be detectable during the log splitter is under operations. [. . . ] Make sure the level of the refilled oil is just between 2 grooves around the Dipstick. Clean the Oil Drain Bolt before thread them back. Make sure they are tightened to avoid leakage before place the log splitter horizontally. Periodically check oil level to ensure it is between 2 grooves around the Dipstick. [. . . ]