User manual MCCULLOCH HT600

[. . . ] Do not use it in areas where fumes from paint, solvents or flammable liquids pose a potential hazard. The log splitter must be always operated by one person only. Other people should keep a safe distance from the work area, especially when the log splitter is under operations. Never use another people to help you with freeing jammed log. [. . . ] everyday eyeglasses have only impact resistant lenses. Do not put the log splitter on the ground for operations. This is awkward operating position that the operator has to bring his face close to the machine, and thus risks being struck by wood chips or debris. Keep you hands away from splits and cracks which open in the log; They may close suddenly and crush or amputate your hands. Do not remove jammed logs with you hands. It will do a better and safer job at its design rate. Never try to split logs larger than those indicated in the specifications table. This could be dangerous and may damage the machine. Don't use log splitter for a purpose for which it was not intended. Don't leave tool until it has come to a complete stop. Improper use of extension cords may cause inefficient operation of the log splitter which can result in overheating. Before moving the log splitter, make sure the Bleed Screw is tightened to avoid oil leaking from this point. Always set logs firmly on the log retaining plates and work table. Make sure logs will not twist, rock or slip while being split. do not force the blade by splitting the log on the upper part. This will break the blade or damage the machine. Break log in the direction of its growing grain. Do not place log across the log splitter for splitting. It may be dangerous and may seriously damage the machine. Do not attempt to split 2 pieces of logs at the same time. After the log pusher moves back and completely stops at its starting position, insert a wedge wood under the jammed log. Start the log splitter to push the wedge wood to go completely under the jammed one. [. . . ] Make sure all moving parts stops and the log splitter is unplugged. Turn the log splitter on the Support Leg side over an 4 liters capacity container to drain the hydraulic oil off. Refill fresh hydraulic oil at the volume as per the hydraulic oil capacity of a particular model indicated in above specifications table. Clean the surface of Dipstick on the Oil Drain Bolt and put it back into the oil tank while keep the log splitter vertically. [. . . ]