User manual MCCULLOCH MCC1435A

[. . . ] Hold chain saw firmly with both hands when using. For your own safety, please read and follow the safety precautions in this manual before attempting to operate your chain saw. With proper operation and maintenance, it will provide you with years of service. Be sure to carefully follow the step-by-step instructions in this manual to start, operate and maintain your new product. [. . . ] (Figure 5-2H) NOTE: If chain turns while idling - turn screw back to the left until chain stops and unit continues to idle. Some conventional gasolines are being blended with oxygenates such as alcohol or an ether compound to meet clean air standards. Your McCulloch engine is designed to operate on any gasoline intended for automotive use including oxygenated gasolines. Always refill the chain oil tank each time the fuel tank is refilled. We recommend using Genuine McCulloch Chain, Bar and Sprocket Oil, which contains additives to reduce friction and wear and to assist in the prevention of pitch formation on the bar and chain. Pull out the choke (A) to the point where it latches in place. Latch throttle advance: depress latch and hold (C) squeeze throttle trigger (D) release trigger and then the latch. Place the saw on a firm and level surface. Hold the saw securely with your foot as illustrated. 5-2E) NOTE: If the engine sounds as if it wants to start before the 4th tug, end the tugging of the starter and proceed as described in the next step. Let the engine run for 10 seconds to warm up. Press the trigger (F) and put it into idle. If the engine does not start up, repeat the above steps. ) your chain saw may need a slight adjustment to the idle speed. After warm up - See the User's Manual section 5-2, step 7 - If unit does not Idle after restarting 2 times, follow these steps to adjust idle. Latch throttle advance: depress latch and hold squeeze throttle trigger release trigger and then the latch. If the engine still can not start, follow the step as "To start engine" section in this user manual. Small trees up to 6-7 inches (15-18cm) in diameter are usually cut in a single cut. When diameter of wood being cut is greater than the bar length, make 2 cuts as shown (Figure 6-1D). Keep the chain from touching anything; don't let the saw tip forward. When it does, immediately release the throttle trigger. A retreat path (A) should be planned and cleared as necessary before cuts are started. [. . . ] PROBLEM Unit won't start or starts but will not run. DURATION The duration of the warranty for this McCulloch product is as follows: ONE (1) YEAR from date of original purchase only when used for personal, family, household, farm or ranch, purposes, provided the unit is not used for rental purposes; NINETY (90) DAYS from date of original purchase when used for commercial, professional, institutional or rental purposes. This warranty gives you specific legal rights. You may also have other rights which vary from state to state. [. . . ]