User manual MCCULLOCH MCT2024

[. . . ] For problems or questions, DO NOT return this product to the store. PLEASE READ For your own safety please read this manual before attempting to operate your new unit. Failure to follow instructions can result in serious personal injury. Spend a few moments to familiarize yourself with your trimmer before each use. [. . . ] This plug will fit in a polarized outlet only one way. if the plug does not fit fully in the outlet , reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not use if the switch does not turn the unit off properly. Never use unit if cord or plug has been damaged, the motor or unit itself is not working as it should or has been dropped, damaged, left outdoors or dropped in water. Never operate with any air opening blocked. Keep air openings free of debris that may reduce air flow. Replace damaged parts that are chipped, cracked or damaged in any way. Power tool built with this insulation system are not intended to be grounded. As a result, the extension cord used with your unit can be plugged into any conventional 120 volt electrical outlet. Normal safety precautions must be observed when operating an electrical power tool. The double insulation system is only for added protection against injury resulting from a possible internal electrical insulation failure. A 2-wire cord without a ground connection may be used since this power tool is double insulated. If in doubt of proper wire size, use the next heavier gauge. Use of these personal safety items is highly recommended to reduce the risk of accidental injury (Figure 2-2). Use of these personal safety items is highly recommended to reduce the risk of accidental injury. If you receive your unit assembled, check each step to insure your unit is properly assembled. Follow all safety information in the manual and on the unit. When starting the string trimmer for the first time, check that the nylon lines touch or pass over the linecutting blade. If they are not long enough, press the button and, at the same time, pull the nylon lines (Fig. Without letting the trimmer touch the grass, press the switch (A) on the upper handgrip (Fig. Let the string trimmer run for a few seconds and "bump" the string head against the lawn. [. . . ] Insert the line through each eyelet in the spool carrier and slide the spool into the carrier. 5-1J) NOTE: Insure that the line is within the clear plastic line retainer. If it's outside of the clear plastic line retainer, the line will not feed. Make sure to insert the spring, assemble the spool and spool carrier back onto the trimmer. [. . . ]