User manual MCCULLOCH MCT2303A

[. . . ] For problems or questions, DO NOT return this product to the store. PLEASE READ For your own safety please read this manual before attempting to operate your new unit. Failure to follow instructions can result in serious personal injury. Spend a few moments to familiarize yourself with your trimmer before each use. [. . . ] The extension cord must be specifically intended for outdoor use and marked "SJ" or "SJT" and with the suffix "WA". Inspect extension power cord for loose or exposed wires and damaged insulation. if damaged , replace before using trimmer. DO NOT ABUSE CORD - Never carry trimmer by cord or pull cord to disconnect from outlet. Keep cord clear of operator and obstacles at all times. Do not expose cord to heated surfaces, oil or water. Do not pull cord around sharp edges, corners or close door on cord. For service information, contact the McCulloch Product Service Department listed on the back cover of this User Manual. RISK OF EYE INJURY - Always wear goggles or other suitable eye protection when operating your trimmer. Edging increases the risk of injury caused by flying debris. Always keep bystanders at a safe distance. DRESS PROPERLY - Always wear long pants, shoes and gloves. Do not wear loose clothing, jewelry, short pants, sandals or go barefoot. KEEP AREA CLEAR - Keep everyone, especially children and pets away from the area of operation. Turn off unit immediately if you are approached. Never allow children to operate the trimmer to be used as a toy or to run unattended at any time. AVOID A DANGEROUS ENVIRONMENT - Do not use in the presence of flammable liquids or gases, smoking or burning materials to avoid creating a fire or explosion. Never operate the trimmer in wet or damp conditions or around swimming pools, hot tub, etc. Do not handle plug, cord or trimmer with wet hands a. Use of these personal safety items is highly recommended to reduce the risk of accidental injury (Figure 2-2). Use of these personal safety items is highly recommended to reduce the risk of accidental injury. NOTE: The only assembly required for your trimmer is to install the edge guide wheel, debris shield and adjust the assist handle. [. . . ] Test area to be trimmed for proper cutting height. Keep stringhead at same level for even depth of cut. Position trimmer straight ahead with a slight tilt so bottom of stringhead is above ground level and string contact occurs at proper cutting point. Always clean dirt and debris from the spool and hub prior to, when the unit is idle, and after performing any type of maintenance. [. . . ]