User manual MCCULLOCH TRIMMAC 251-25CC

[. . . ] TrimMac 251 GB sure you understand them before using this unit. Retain these instructions for future reference. INSTRUCTION MANUAL IMPORTANT INFORMATION: Please read these instructions carefully and make FR atentivement les instructions et assurez-vous de les avoir comprises. Conservez les instructions pour référence ultérieure. MANUEL D'INSTRUCTIONS RENSEIGNEMENTS IMPORTANTS: Avant d'utiliser cet appareil, veuillez lire DE Geräts aufmerksam durch. Verwenden Sie es erst, wenn Sie sicher sind, daß Sie alle Anweisungen verstanden haben und gut aufbewahren. BETRIEBSANWEISUNG WICHTIGE INFORMATION: Lesen Sie diese Hinweise zur Handhabung des ES asegúrese de entenderlas antes de utilizar esta aparato. [. . . ] To avoid engine problems, empty the fuel system before storage for 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur. 9. HOW TO STOP YOUR UNIT S To stop the engine, move the ON/OFF switch to the OFF position. HOW TO START YOUR UNIT WARNING: The trimmer head will turn while starting the engine. A hot muffler can cause serious burns. STARTING A COLD ENGINE (or a warm engine after running out of fuel) Starting Position STARTING A WARM ENGINE Set unit on a flat surface. Move choke lever to FULL CHOKE position. Squeeze and hold trigger through all remaining steps. Pull starter rope handle sharply until engine sounds as if it is trying to start, but do not pull rope more than 6 times. As soon as engine sounds as if it is trying to start, move choke lever to HALF CHOKE. Pull starter rope sharply until engine runs, but no more than 6 pulls. If the engine doesn't start after 6 pulls (at the HALF CHOKE position), move the choke lever to the FULL CHOKE position and press the primer bulb 6 times. Squeeze and hold the throttle trigger and pull the starter rope 2 more times. Move the choke lever to the HALF CHOKE position and pull the starter rope until the engine runs, but no more than 6 pulls. NOTE: If engine still doesn't start, it is probably flooded. Once the engine starts, allow it to run 10 seconds, then move the choke lever to OFF CHOKE. Allow the unit to run for 30 more seconds at OFF CHOKE before releasing the throttle trigger. NOTE: If engine dies with the choke lever in the OFF CHOKE position, move the choke lever to the HALF CHOKE position and pull the rope until engine runs, but no more than 6 pulls. 1. Move the choke lever to the HALF CHOKE position. Rocks or debris can ricochet or be thrown into eyes and face and cause blindness or other serious injury. Do not run the engine at a higher speed than necessary. The cutting line will cut efficiently when the engine is run at less than full throttle. At lower speeds, there is less engine noise and vibration. The cutting line will last longer and will be less likely to "weld" onto the spool. [. . . ] Slowly pull the starter rope 8 to 10 times to distribute oil. S Replace spark plug with new one of recommended type and heat range. S Check entire unit for loose screws, nuts, and bolts. Replace any damaged, broken, or worn parts. [. . . ]