User manual MCINTOSH CR16 SERVICE MANUAL

[. . . ] Follow Instructions - Follow all operating and use instructions. WARNING: TO REDUCE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS INSTRUMENT TO RAIN OR MOISTURE. 5. Power Sources - Connect the power supply only to the type described in the operating instructions or as marked on the unit. Power-Cord Protection - Route power-supply cords so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the instrument. Ventilation - Locate the instrument for proper ventilation. [. . . ] This will allow you to customize your remote control system so it will satisfy all your particular needs. The CR16 system includes the following performance capabilities. Contact your Mclntosh dealer for any other specific system requirements you may have. FOUR INDEPENDENT CONTROL AREAS The CR16 is shipped with two Area Control modules installed, for area one and area two. Slots are provided to install two additional Model ACM-1 Area Control modules to allow control of two additional remote areas, for a total of four. SIX PROGRAM SOURCES Six separate source input signals can be used. These are CD (compact disc player or changer), TUNER, TAPE 1, TAPE 2, VIDEO and Auxiliary. Any of these six audio input signals can be selected for any remote location. PRE-PROGRAMMING CAPABILITY You can select the source program signal as well as the desired volume setting for each area before the area amplifier is turned on. FRONT PANEL LED STATUS INDICATORS Long life LED indicators show, 1. Which input signal is selected for each remote area, 2. As an example, you could turn lights on or off, or raise and lower a motorized TV screen. 6 The CR16 can be installed in a custom cabinet, or in a Mclntosh L72 equipment cabinet. Every CR16 Remote Control System is special, and can be customized for your particular needs. Your Mclntosh dealer can assist you in the design of the system configuration. Your dealer is also prepared to do both the installation and connections for you. INSTALLATION AND CONNECTIONS The back cover of this manual folds out to show photographs of the front pane!of the CR16 and the HR10 hand held remote controller. Fold it out to assist you In locating and identifying the pushbuttons and displays. The numbers and letters on the photographs refer to the information that follows. 1. AREA INPUT SELECTION INDICATORS These indicators show what input signal source has been selected for each area. AREA POWER ON INDICATORS These indicators show which areas are turned on and operating. AREA PROGRAM INDICATORS These indicators show which area is selected for programming input sources and volume level. SENSOR The front panel IR sensor that accepts signals from the HR10 hand held remote controller. [. . . ] This allows you to select all tuner functions with the HR10 Hand Held Remote Controller. I. CD CONTROL Connector to add an optional model W101 cable to a Mclntosh CD Player or Changer. This allows you to select four operating functions on the Mclntosh CD Player and six functions on the CD changer with the HR10 Hand Held Remote Controller. 9 REAR PANEL CONNECTIONS J. POWER CONTROL Connector to add the cable from a Mclntosh PC-1 Power Controller. [. . . ]