User manual MCINTOSH D751

[. . . ] OWNERS MANUAL MCD751 Compact Disc Transport MCD751 McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549 Thank You, Please Take A Moment, Customer Service and Table of Contents Thank You Your decision to own this McIntosh MCD751 Compact Disc Transport ranks you at the very top among discriminating music listeners. The McIntosh dedication to Quality, is assurance that you will receive many years of musical enjoyment from this unit. Please take a short time to read the information in this manual. [. . . ] The Data In/Out for remote control operation from another McIntosh component. Special Power Supply A fully regulated power supply with a special power transformer ensures stable noise free operation even though the power line should vary. · Installation Installation The MCD751 can be placed upright on a table or shelf, standing on its four feet. It also can be custom installed in a piece of furniture or cabinet of your choice. The required panel cutout, ventilation cutout and unit dimensions are shown. Always provide adequate ventilation for your MCD751. Cool operation ensures the longest possible operating life for any electronic instrument. Do not install the MCD751 directly above a heat generating component such as a high powered amplifier. If all the components are installed in a single cabinet, a quiet running ventilation fan can be a definite asset in maintaining all the system components at the coolest possible operating temperature. A custom cabinet installation should provide the following minimum spacing dimensions for cool operation. Allow at least 2 inches (5. 1cm) above the unit and 1 inch (2. 54cm) on each side of the control center, so that airflow is not obstructed. Allow 16 inches (40. 64cm) depth behind the mounting panel, which includes clearance for connectors. Allow 3/4 inch (1. 9cm) in front of the mounting panel for clearance. When a Power Control cable is connected to a McIntosh DA Converter or Control Center, the MCD751 POWER SWITCH can be left on, and the player will turn on automatically whenever the other component turns on. Refer to front panel drawing on the opposite page. The Red LED above the pushbutton will start flashing and the disc tray will slide out. The front panel display will indicate OPEN. Place a disc within the guides, on the tray with the label facing up. Press the OPEN/CLOSE pushbutton a second time. The Red LED above the pushbutton will start flashing, the display will indicate CLOS and the disc tray will close. The LED will stop flashing and stay on as Figure 2 long as a disc is in the tray or playing. After the disc tray closes, for a few seconds the Time display will indicate the total number of tracks and total play time of the disc Figure 3 just inserted. Disc Play Modes Listed below are six different modes for playing all or part of a Compact Disc: Standard Play 1. Press the PLAY pushbutton and play will start from the first track on the disc. Note: After a disc is inserted in the tray, you can also press just the Play pushbutton to both close the disc tray and start playing the disc. [. . . ] Clear Press CLEAR to erase a selected track and replace with another track. Review Press REVIEW to show on the display the details of the first track selected to play in random order or a track deleted from playback. Each time the REVIEW pushbutton is pressed, the display will show the details of the next track selected or deleted. Delete Press DELETE and then one or more NUMBER pushbutton(s) to delete tracks on a disc that you do not want to play. [. . . ]