User manual MEDION 19 TFT DISPLAY MD 30519 PA

[. . . ] 19 Inch TFT Color Monitor Operating Instructions © 2006 All rights reserved. This manual is protected by Copyright. The Copyright is owned by Medion®. Trademarks: MS-DOS® and Windows® are registered trademarks of Microsoft®. Pentium® is a registered trademark of Intel®. Other trademarks are the property of their respective owners. [. . . ] Perform this step before connecting the monitor. (similar picture) Connecting the Monitor To start using the TFT monitor straight away, please read the "Safety Instructions" section (page 2). We recommend that you also read all the other sections as these contain detailed explanations and tips on how to use your TFT display. Power supply D-SUB DVI Audio (similar picture) 1. Ensure that the TFT monitor is not yet connected to the line power (power cord not yet plugged in) and neither the TFT monitor nor the computer is switched on. Prepare your computer for the TFT monitor if necessary (see previous pages) with the correct settings for your TFT. Connecting VGA / DVI Signal Cable 3. Plug the signal cable into the matching VGA sockets on the computer and on the monitor. If your PC also has a DVI output, you can connect your monitor by means of the DVI connector. Connecting Audio Cable 4. Plug the audio cable into the matching sockets on the computer and on the monitor. 8 ENGLISH Connecting the Power Supply 5. Plug the power supply cable into the power supply socket of the TFT screen and plug the electric plug into a socket close to the TFT screen (same circuit). Your monitor has an ON/OFF switch at the rear side, by means of which you can switch the monitor on or off, on the back. If the switch is set to 0, then no power is consumed. Set the switch to I and next switch your monitor on using the on/off switch. Then switch on your computer. Positioning of the Monitor Please ensure that the monitor is set up in such a way that that reflections, glare and light-dark contrast are avoided (as this will make the screen less attractive to look at) Your posture Sitting in one position for long periods can be uncomfortable. To minimize the potential for physical discomfort or injury, it's important that you maintain proper posture. Back - While sitting at your work surface, make sure your back is supported by the chair's backrest in an erect position or angled slightly backwards. Arms - Your arms should be relaxed and loose, elbows close to your sides, with forearms and hands approximately parallel to the floor. Wrists - Your wrists should be as straight as possible while using the keyboard, mouse or trackball. They should not be bent sideways, or more than 10 degrees up or down. Head - Your head should be upright or tilted slightly forward. Avoid working with your head or trunk twisted. Legs - Your thighs should be horizontal or angled slightly downward. Your lower legs should be near a right angle to your thighs. Your feet should rest flat on the floor. [. . . ] · Type 2: A pixel that does not light up (dark, black spot), although it is addressed. · Type 3: Abnormal or defective red, green or blue sub-pixels. constantly lit with half the brightness, one color is not shining, blinking or flickering, but not belonging to Type 1 or 2 Pixel Failures). In addition: A cluster of type 3 (= 2 or more defective sub-pixels in an array of 5 x 5 pixel). [. . . ]