User manual MEDION 42 PLASMA DISPLAY MD 41842

[. . . ] Installation And Start-up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Chapter 7. 4 7. 5 7. 6 7. 7 7. 8 7. 9 7. 10 7. 11 7. 12 7. 13 7. 14 7. 15 Description Pages 44 44 44 44 44 44 44 44 45 45 45 45 Colour Display . . Important: The supplier constantly strives to improve the quality of product documentation. As our customer, you can contribute to this. [. . . ] Please use only the enclosed signal cable for connection. The plasma display is suitable for utilisation together with compatible computers. Your PC has one of the following configurations: · A built-in graphics adapter. Both variations have one analogue and one digital video output jack for connection of a monitor. If you 20 For the connection of your monitor to the system, proceed as follows: 1. Turn off the power supply to the computer and the display. In case it is necessary, install a graphics card according to the directions in the graphics card user manual. Make sure that the graphics card utilised generates a video format that lies within the limits which are stated in the specifications (VGA, XGA). Connect the signal cable to the display's signal input (DVI-I), and to your computer's corresponding video jack (15-pin mini D-DUB) or DVI. Attention: Falsely connected signal cables can lead to irregularities in monitor operation, a poor image quality or damage to the display, and shorten service life as a result. 7. You can store frequently used formats as user formats. The display recognises these formats, and immediately presents them in correct fashion without execution of the auto-adjust function. PC playback), the image is still slightly visible in the full mask for a few minutes during the subsequent playback of a different source. This is known as "image sticking". This "vanishing" residual image is caused by the system, and does not represent a flaw. Therefore it cannot be considered as a case for warranty claim. Video cable A high-quality 75 coaxial cable should be utilised for the connection of the video signal. Poor quality signal cable can result in strong disturbances and formation of shadows in the displayed image, as well as exceeding the permissible EMC level. The mechanical interlocks of the individual plug-and-socket connectors are necessary for perfect and safe operation of the device. 21 ! CAUTION 4 Remote control 4. 1 Direct Functions 22 · The remote control only functions if the plasma display has been turned on with the mains switch beforehand. STDBY After you have turned on the display once with the mains switch, you can turn it on and off with the remote control (stand-by). Press the keys TV, VIDEO, PC, or 1, 2, . . . Press the stand-by button in order to switch the display into stand-by mode. CAUTION: If the display has been turned on in standby mode, it is still linked with the mains. For complete disconnection you must first switch the mains switch into the "off" (0) position, and then pull the mains cable. TV VIDEO You can switch directly to TV mode with this key. [. . . ] The following menus are available for you: Info, Sound, Image, Display, Inputs and Settings. The most important functions such as channel switching, format switching, switching of TV / VGA mode and volume are provided directly on the remote control. · Audio equaliser In addition to volume and balance control, 5 OSD slide controls (120 Hz, 500 Hz, 1. 5 kHz, 5 kHz, 10 kHz) for sound influence are available to you. · Multisync VGA display The multisync technology enables operation on different PC formats ­ from VGA to XGA, up to a maximum clock frequency of 95 MHz. [. . . ]