User manual MEDION CD MP3 USB CAR RADIO MD 80947

[. . . ] Card reader (on the upper side of the control panel) OPEN : Open control panel SEL: Press repeatedly to call up the following audio settings: volume, bass, treble, balance, fader; In traffic announcement mode: Press repeatedly for a little longer to call up the various traffic announcement settings During MP3 title search: During MP3 search using letters confirm every entry; MULTIJOG: control dial: adjust selected audio settings (SEL) Display 0 / DSP: number key 0 / switch display mode ENT: confirm selection / LOU: loudness / BND: band selector EQ (Equaliser): press repeatedly to change tone settings PWR: turn device on/off (the device can also be turned on with any other key except OPEN) DIM (tap): dim display USB connection (behind protective cover) RESET opening: reset to factory settings AF/REG: press for a short time to start RDS mode press longer to switch to regional mode REC: record on device connected via USB TA (Traffic Announcement): activate the TA function PTY (Program Type): press once to search for stations from the PTY group "music"; press twice to search for stations from the PTY group "speech"; press three times to turn off PTY 1/ PAU: number and station key 1 / pause play in CD/MP3 mode 2 / SCN: number and station key 2 / scan function in CD/MP3 mode 3 / RPT: number and station key 3 / repeat function in CD/MP3 mode 4 / SHF: number and station key 4 / shuffle function in CD/MP3 mode 5 / DIR : number and station key 5 / MP3 search downwards 6 / DIR : number and station key 6 / MP3 search upwards 7 / MOD: number key 7 / select operating mode Radio CD/MP3 USB ­ Card reader AMS (Automatic Memory Search): automatic saving of stations 8 / TUN/TRK : number key 8 / station search backwards 9 / TUN/TRK : number key 9 / station search forwards Red LED (anti theft protection) CD compartment EJECT: eject CD About these instructions Please read these instructions carefully before using the device. note the warnings on the device and in the operating instructions Store the operating instructions in the car. If you sell or give the car radio away, please ensure that you also pass on these instructions. Keep electrical equipment out of reach of children Never allow children to use electrical devices unattended. [. . . ] After the search function has found a station press one of the M1-6 (10 15) buttons for around three seconds. a beep will sound to indicate that the station has been stored. In each band (FM1, FM2, FM3, MW and LW) you can save 6 stations. The radio will switch back into automatic search mode after a few seconds. You can open one of the saved stations by pressing one of the station buttons 1-6 (14 19). Hold down the AMS (21) button for about three seconds. The three frequencies FM1, FM2 and FM3 are searched for the six strongest stations and the stations found are saved in programme spaces 1 6 for each frequency range. Then the station that is saved in memory space 1 in frequency FM1 is played. You can call up the saved stations for the current transmission areas. All stored stations will be played one after another for about five seconds. ⷠWhen you hear the station you want to listen to press the AMS button (21) briefly. In addition to traditional music and voice services they also broadcast additional information in the form of encrypted digital signals and these are analysed and displayed by the car radio. On the display you can now see the programme name and other information (traffic information, the title of the track currently being played, etc. In the AF table in RDS alternative frequencies for neighbouring transmitters with the same programme are constantly being sent out. The receiver constantly checks the quality of the received signal and, if necessary, changes to another frequency. The change is only successful if the PI codes are identical. This avoids switching to a frequency which is occupied by a different programme. To switch the regional programme mode on or off hold down the REG/AF button (11) for longer than 2 seconds. To switch on the regional mode wait until the display changes back to the radio display. REG ON: The radio only searches regional stations with traffic announcements. REG ON: The radio only searches stations with traffic announcements outside of the region. Press the TA button (12) for a little longer to switch this function on or off. [. . . ] Insert a memory card into the drive with the label side facing upwards. The controls for playing files are the same as for MP3 CDs. ⷠIf the device is in another mode (radio, CD or USB), you can select the card reader with the MOD (20) button. You can use your radio to record data from the radio and the CD player onto a memory card. [. . . ]