User manual MEDION E3212 MD 96860

[. . . ] We have structured these Operating Instructions for the installation so that you will be able to look up the necessary subject-related information by means of the Contents List at any time. note You will find comprehensive Operating Instructions for navigation on the DVD and online. Read the section "Frequently Asked Questions" to obtain answers to questions that are often addressed to our customer service. It is important to document the details of your Navigation Unit purchase in the event you need warranty service. [. . . ] Under certain circumstances it may be necessary to install an external GPS antenna (see page 47). Only fix the holder for the navigation system to the windscreen, if it does not impede the view. Should this not be possible, then mount the holder with the enclosed suction plate in any way that will allow peril-free and safe operation. Place the holder with the suction head directly onto the wind screen and press the lever on the suction head downwards. Connect the car adapter (see page 12) and, if necessary, the TMC aerial and the external GPS aerial, to your navigation system and insert the memory card. Now, push the unit downwards until it engages audibly. Now you will be able to place the complete unit on the cleaned windscreen or the suction plate. Plug the jack ( ) of the connection cable into the corresponding receptor at the bottom of your navigation system (p. Insert the power adapter ( ) into the cigarette lighter socket and ensure, that it will not lose contact while driving. Note Remove the power adapter from the cigarette lighter socket when ending a trip or when parking the car for a extended period of time. Otherwise the car battery could be drained. In this case use the power switch to turn off the navigation system. Note Your memory card will always have to be inserted into the device during the use of the navigation system, if the card contains (additional) mapping material. It will be necessary to carry out a reset to restart the navigation system if the memory card has been removed while the system was being used (see page 22). According to the navigation system the reset is carried out automatically. The Navigation software will start automatically or after tapping on the navigation control button on the main screen, according to the version. After a short time, if the satellite reception is adequate you will receive augmented language statements. Further information regarding the navigation software can be found in the comprehensive manual on your navigation DVD. This is a pdf-file you can read and print with the any Acrobat Reader. Note The GPS-receiver will require some minutes for initialization when deployed for the first time. Even when GPS signal reception is indicated the navigation could be imprecise. In all future instances it will take about 3060 seconds until a correct GPS-signal is available, sufficient "sight" of the satellite is a prerequisite. [. . . ] The GoPal Assistant supplied with the device enables a simple and individual compilation of the map material to be transferred. Depending on the amount of map data on the navigation DVD, memory cards with capacities of 256 MB, 512 MB, 1. You can obtain additional memory cards (MMC or SD cards) in specialist stores. Transfer of card material to a memory card The transfer of additional card material to a memory card can take place through Explorer on your PC via the following steps: Insert the DVD with the card material required. [. . . ]