User manual MEDION GOPAL NAVIGATOR 3.1 MEAE

[. . . ] User Manual Navigation Software -2- Table of Contents 1 Starting up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. 1 Important information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. 2 Alternative installation of navigation software from a memory card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. 3 Transferring map material to a memory card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If this is not the case, remove files that are not required. ® 1. 5 Data transfer (GoPal Assistant) Install the GoPal Assistant on the CD/DVD onto your PC in order to use the following configuration options: -7- Transferring the installation files Transfer map material -8- 2. Operating the navigation software This chapter contains information about the following subjects: 2. 1 Symbols 2. 2 Map 2. 3 Destination 2. 4 Route 2. 5 View 2. 6 Settings -9- 2. 1 Symbols Symbols in menus Use this symbol to access the menu bar. Use this symbol to access the View menu. Use this symbol to access the Destination menu. Use this symbol to access the Route menu. Use this symbol to access the Settings menu. Use this symbol to access the Help menu. Use this symbol to access the previous screen. Use this symbol to confirm the entry and move to the next screen. Use this symbol to exit the navigation software. Symbols on map Press this symbol to access the compass. This symbol dispays the battery status of the device. Use this symbol to check GPS signal quality and by clicking on the symbol you can change to Compass view. Current traffic information can be received via the TMC module, which will then be displayed on the map with a corresponding traffic symbol. A warning symbol on the map as well as an acoustic warning will alert you to the nearest traffic hold-ups on your route that affect your travelling time. Clicking on the warning symbol will take you to the traffic warning view. The navigation software automatically completes the address when searching for a destination. After entering just a few characters, you will be shown the three best results along with the list of all possible results. If the place you are looking for does not appear on the list, you may have to enter more detailed information for the address. Note You can also follow your current position on the map without entering a destination. If available, the name of the street you are currently on will be displayed. 2. 3. 2 Points of interest You can use the search category to determine the type of destination. By default, the program will search for the road/street of the entered address. [. . . ] The design of the map is adjusted to daylight or darkness, depending on the time of day. During the manoeuvre the map changes automatically into arrow view. After the manoeuvre the display changes back to map view. Map view remains on display also during a manoeuvre. [. . . ]