User manual MEDION LCD TV MD 30120

[. . . ] 20 Inch Flat Panel LCD - TV © 2005 All rights reserved. Trademarks: MS-DOS® and Windows® are registered trademarks of Microsoft®. Pentium® is a registered trademark of Intel®. Other trademarks are the property of their respective owners. [. . . ] Follow the steps below and use P+/ P-, VOL+/ VOL- and MENU buttons on your remote controller to configure First Setup. 4. 5. First Setup (Country) First Setup: Country: Greatbritain Nederlands First Setup (Language) First Setup: Country: Greatbritain Language: English 6. FIRST TIME INSTALLATION 21 Türkçe Português Español Dansk Français Italiano English Deutsch 6. The preferred method at First Setup is Auto Scan. Please refer to the Manual Scan Programs section ( p. 31) for detailed instructions on how to operate Manual Scan. First Setup AUTO SCAN First Setup: Country: Greatbritain Language: English Scan: Auto Scan 7. 8. The system with automatically scan frequencies for available channels. After First Setup is completed, the Program List will appear on the screen. You can rename, delete, and insert programs within the Program List. (For details, see "Editing Programs" p. GENERAL CONTROLS & ADJUSTMENT TURNING THE LCD DISPLAY ON AND OFF Press the POWER button on the Remote Control. 1. Turn on the power of the connected video equipment. Press the applicable button. Press Press Press Press Press Scart TV button to switch to TV mode. AV2 button to switch to Component (YPbPr) mode. SCART button to enable the system to auto detect between (Video/ S-Video/ RGB) modes. When pressing the signal source key on your LCD-TV, the device will recognize the signal source automatically. VOLUME CONTROL USING VOLUME CONTROL Press VOL-/ VOL+ button to turn up or turn down the sound volume. USING MUTE Español At any time, you can temporarily turn off the sound by pressing the MUTE button. Press the MUTE button and the sound cuts off. Press the MUTE again or VOL- / VOL+ button to turn the sound back to the previous level. Note: The mute function is automatically turned off if VOL- / VOL+ is pressed. 7. GENERAL CONTROLS & ADJUSTMENT 23 Türkçe Português Dansk Nederlands Français Italiano SWITCHING SIGNAL SOURCE English Deutsch SETTING THE SLEEP TIMER You can set the Sleep Timer to automatically turn off the TV view of LCD display. Press the SLEEP button to display the Sleep Timer screen. Press the SLEEP button repeatedly to change the sleep time (in minutes). The time can be set to 10-minute increments from 10 minutes to 120 minutes. Note: The Sleep Timer screen automatically disappears in 10 seconds. VIEWING THE MENUS AND ON-SCREEN DISPLAYS 1. With the power on, press the MENU button. The main menu appears on the screen. Picture Sound Colour TV Reset : Adjust : Enter Page: 2/2 Page: 1/2 Mode Input Exit :Adjust : Enter 2. [. . . ] Our service includes unit exchange or send-in repair: Unit Exchange In locations where Unit Exchange is available, we will send you a replacement unit. You must return the defective unit to our company (using the shipping carton that the new one came in. ) Send-In Repairs In locations where Send-In Repair Service is available, repair service can be obtained by shipping your unit to the Repair Center. The unit will be repaired and returned to you. For either Unit Exchange or Send-In Repairs, you must have an authorized RMA number from our support before shipping your defective product. [. . . ]