User manual MEDION MD 41530 30 LCD DISPLAY

[. . . ] 30 Inch Flat Panel LCD - TV © 2004 All rights reserved. Trademarks: MS-DOS® and Windows® are registered trademarks of Microsoft®. Pentium® is a registered trademark of Intel®. Other trademarks are the property of their respective owners. [. . . ] You will switch up and down between the channels in your channel table with the P+/P- buttons. You can select the required channel directly with the assistance of the number block on the remote. Press the RTN button if you want to call up the channel viewed most recently. VOLUME CONTROL USING VOLUME CONTROL Press VOL-/ VOL+ button to turn up or turn down the sound volume. USING MUTE At any time, you can temporarily turn off the sound by pressing the MUTE button. Press the MUTE button and the sound cuts off. Press the MUTE again or VOL- / VOL+ button to turn the sound back to the previous level. Note: The mute function is automatically turned off if VOL- / VOL+ is pressed. SETTING THE SLEEP TIMER You can set the Sleep Timer to automatically turn off the TV view of LCD display. Press the SLEEP button to display the Sleep Timer screen. Press the SLEEP button repeatedly to change the sleep time (in minutes). The time can be set to 30-minute increments from 30 minutes to 90 minutes. Note: The Sleep Timer screen automatically disappears in 3 seconds. 7. GENERAL CONTROLS & ADJUSTMENT 23 Türkçe Português Español Dansk Nederlands Français Italiano English Deutsch VIEWING THE MENUS AND ON-SCREEN DISPLAYS 1. With the power on, press the MENU button. The main menu appears on the screen. PICTURE COLOR TEMP SOUND TV MONITOR RESET MODUE INPUT :SELECT :ADJUST 2. Use the P+ / P- button to select one of the menu options, and then press the MENU button to access to the Sub-menu. Carry the changes out with the VOL+/VOL- buttons. Press the EXIT button to return to the previous screen or select END and confirm with MENU button to leave the Menu. Note: The menu varies with which input source is selected. 24 ENGLISH CONTRAST AND BRIGHTNESS SETTINGS You may need to perform separate adjustments for brightness and contrast for the different video modes. Press the MENU button to display the main menu. Press the P+ / P- button to move cursor to PICTURE. To set the brightness: select the BRIGHTNESS menu point and press the VOL+/VOL- buttons to increase or lower the screen brightness. To set the contrast: select the CONTRAST menu point and press the VOL+/VOL- buttons to increase or lower the screen contrast. This function locks the LCD-TV to prevent unauthorized access. Press the MENU key to open the main menu. Go to the function Child Lock using the P+/P- keys. Enter a four-digit PIN through the remote and confirm it with the MENU button. [. . . ] You must return the defective unit to our company (using the shipping carton that the new one came in. ) Send-In Repairs In locations where Send-In Repair Service is available, repair service can be obtained by shipping your unit to the Repair Center. The unit will be repaired and returned to you. For either Unit Exchange or Send-In Repairs, you must have an authorized RMA number from our support before shipping your defective product. Replacement products may be either new or equivalent in performance to new. [. . . ]