User manual MEDION MD 80383

[. . . ] Univ-FB_MD80383_AUS. fm Seite 2 Dienstag, 24. Januar 2006 8:57 08 Contents Overview . Entering the device code according to the Code List . 10 10 11 12 13 14 15 15 15 16 17 17 18 19 19 20 21 21 21 2 Univ-FB_MD80383_AUS. fm Seite 3 Dienstag, 24. [. . . ] Please note: - In certain circumstances, not every function of your original remote control may be directly available on the universal remote control. - Especially for newer devices, it might be possible that the functions are stored to different keys than expected or may not even be available at all. In these cases you can use the learn function to transfer the functions of your original remote control to the desired keys of the universal remote control ("Learn function", page 17). Recording with the video recorder The RECORD key for recording to video recorder must be pressed twice. This acts as a protection from accidental recordings. 15 Univ-FB_MD80383_AUS. fm Seite 16 Dienstag, 24. Januar 2006 8:57 08 Operating combined devices Several controlling options are available to combined devices. Combined devices with two device codes Some combined devices (e. g. TV set with video recorder) require two device codes - one for each device part. The combined device is then controlled like two separate devices. Combined devices with one device code Other combined devices only require one code. In this case, you must first select the device part you would like to operate. Example: The device is a combined DVD recorder/video recorder. The device code was stored on the DVD source key. Now activate the DVD part in the combined device by holding down the DVD source key for longer than one second. To activate the video recorder in the combined device, first briefly press the S (SETUP) key, then the DVD source key. If your combined unit only requires one code but you would like to operate it with two source keys, then proceed as follows: Programme the device code to two source keys. Operate one of the unit parts with one of the two source keys. Use the learn function (see next chapter) to transfer the desired functions of the other unit part to the other source key. 16 Univ-FB_MD80383_AUS. fm Seite 17 Dienstag, 24. Januar 2006 8:57 08 Learn function You can manually save the functions of an original remote control to your universal remote control. The universal remote control can "learn" up to 150 commands. Notes on learn function Use new batteries for both remote controls. One original remote control can be saved to every source key (8in-1 function). Once the memory is full, the background lighting of the source key will flash for 3 seconds. If you are programming an additional function to an existing code, please take note which keys are still unassigned beforehand. The following keys cannot be assigned to functions: LEARN, S (SETUP), ALL OFF, MACRO, EPG and all source keys. Some original remote controls (for DVD, video recorder, SAT) can themselves be programmed with the device codes of some TV brands to carry out basic TV set functions (volume, mute, channel search). [. . . ] Keep the SETUP key pressed down for approx. 3 seconds until the background lighting of the source key flashes for a short time and then remains permanently lit. (Briefly pressing the SETUP key will activate the SHIFT function. ) 2. Press the key until the source key light extinguishes. [. . . ]