User manual MEDION TFT DISPLAY MD 30159

[. . . ] 19 Inch TFT Color Monitor Operating Instructions © 2007 All rights reserved. Trademarks: MS-DOS and Windows are registered trademarks of Microsoft . Pentium is a registered trademark of Intel . Other trademarks are the property of their respective owners. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · · · · Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Shielded interface cables, if any, must be used in order to comply with the emission limits. 4 English Declaration of Conformity According to 47CFR, Parts 2 and 15 for Class B Personal Computers: We: Medion Aktiengesellschaft____________ (Name of the Responsible Party) Located at: Gänsemarkt 16 ­ 18_________________ D-45127 Essen_____________________ Germany__________________________ (Address, City, State, Zip Code) Fax : 0 201 / 81 081 ­ 227____ (Facsimile Number for conformity issues only) Declare under sole responsibility that the product identified herein, complies with 47CFR Parts 2 and 15 of the FCC rules as a Class B digital device. Each product marketed, is identical to the representative unit tested and found to be compliant with the standards. Records maintained continue to reflect the equipment being produced can be expected to be within the variation accepted, due to quantity production and testing on a statistical basis as required by 47CFR §2. 909. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. The above named party is responsible for ensuring that the equipment complies with the standards of 47CFR §§15. 101 to 15. 109. Trade Name: Type or Model Number: Party Responsible: Executed on (Date), at (Place): Medion MD 30999 PD MEDION AG 6th of June, 2007, Essen Safety and Precautions 5 Start-Up Note Before start-up always read the Chapter "Safety and Precautions" on page 1ff. Mounting the Monitor Stand Mount the monitor stand as shown in the diagram. Perform this step before connecting the monitor. (Ill. : Mounting the monitor stand) Preparations on Your Computer If you have operated your computer previously with a CRT monitor, it will be necessary for you to make a few preparations. This is required when your previous monitor was operated with settings which are not supported by your new TFT monitor. Supported Monitor Settings This TFT monitor supports the following modes: Resolution 720 x 400 640 x 480 640 x 480 640 x 480 800 x 600 800 x 600 800 x 600 1024 x 768 1024 x 768 1024 x 768 1280 x 1024 1280 x 1024 1440 x 900* Horizontal Frequency 31. 47 KHz 31. 47 KHz 37. 86 KHz 37. 5 KHz 37. 88 KHz 48. 08 KHz 46. 87 KHz 48. 36 KHz 56. 48 KHz 60. 02 KHz 63. 98 KHz 80. 00 KHz 55. 47 KHz Vertical Frequency 70 Hz 60 Hz 72. 8 Hz 75 Hz 60. 3 Hz 72. 2 Hz 75 Hz 60 Hz 70. 1 Hz 75 Hz 60. 02 Hz 75 Hz 59. 90 Hz *recommended physical resolution 6 English Windows 9X/2000/ME/XP: Display Properties This Windows program offers you the possibility of adapting the display to your monitor. This includes items such as the background image, the screen saver, the Active Desktop (Web) as well as other settings for your monitor and video card. The program can be started as follows: · · Right mouse click on Windows desk top and left mouse click on "Properties". Or Start the "Display" program in "System control". (Ill. : Display Properties) The resolution can be set under "Screen resolution" ( ). Your monitor can display a maximum of 1440 x 900 image dots. This resolution corresponds to the physical resolution. TFT monitors achieve complete image quality at the physical resolution. Then click "Color quality" ( ) to set the color depth (number of colors displayed). [. . . ] But this can be difficult and varies widely between different manufacturers. MEDION, therefore, adheres to the clear and strict requirements of ISO 13406-2, class II, for the warranty handling of all TFT display products. These requirements are summarized below. Within ISO-standard 13406-2 the general requirements regarding pixel defects are defined. [. . . ]