User manual MELICONI FULLY 8

[. . . ] This note will be handy if you have to reprogram your remote control. Read these instructions carefully before programming your remote control!To command your appliances, you must program your FULLY 8 as described below in A or B . Look for the brand of your appliance in the code list at the end of this booklet and make a note of the corresponding code indicated alongside (e. [. . . ] Identify and take note of the code which you have searched for following the code noting procedure NOTE: during the search operation, the light indicator flashes more quickly. The light indicator stops flashing and the remote control leaves the programming mode in the following cases: · If no keys are pressed for 12 seconds · This operation may take a few minutes. Hold down the selection key for the appliance to be programmed for 5 seconds ( TV . ADSL ), until the light indicator at the top starts to flash indicating that the remote control is ready for programming. Release the keys and enter the code 0000 within 15 seconds. The light indicator flashes more quickly to indicate that the remote control is ready for the search. Press and slowly release the key several times or for the VCR and DVD. Stop when the appliance responds correctly to the command transmitted. When the appliance responds correctly, press the OK key to confirm the selection. three long flashes indicate that the operation has been completed correctly. Additional check Check that some of the other functions used on your original remote control are working correctly. If the commands function incorrectly or erratically, you have probably entered a code for a similar but different remote control. In this case, repeat the search procedure from point 2. Identify and make a note of the code which you have searched for following the code noting procedure Remember to note down always the 4-digit code for the appliances, located under the battery cover, when the search and programming are complete. The codes will be required if the remote control must be re-programmed following accidental deletion. Press the select key for which you want to know the code and hold down for 5 seconds ( TV . ADSL ), until the light indicator at the top starts to flash indicating that the remote control is ready for programming. Release the selection key and within 8 seconds press and release the key. After a few seconds, the light indicator communicates the code you are looking for by flashing the four numbers separately. Count the number of flashes for each code number. [. . . ] When you press a key the light indicator flashes and the appliance does not respond to commands. The remote control commands are not all working correctly. reset the remote control by repeating programming procedure A or B . Set the remote control code, following the global search programming procedure B . [. . . ]