User manual MELICONI PRATICO 2

[. . . ] So use one of the following methods to identify the correct code and set it in your remote control: A) - INTERNET (recommended) B) - CELL PHONE (SMS) C) - MANUAL SEARCH SETTING CODES USING INTERNET If you have an Internet connection available, follow the on-line guide on the www. Com/guide website to identify the specific codes for the devices you wish to command. Then set the codes manually in your MELICONI remote control as described in the ENTERING THE CODE DIRECTLY procedure. SETTING CODES USING A CELL PHONE (the service s fee and the only cost is that of sending the SMS, which naturally depends on the rates of the service operator in question) Today, Meliconi gives customers who don’t have internet the chance to receive the codes for programming their remote control directly on their cell phone. [. . . ] If the device does NOT switch off, press the same button again slowly (it may be necessary to press the button several times). Three long flashes indicate that the operation has been carried out correctly. CHECK Check that the other buttons correspond to the functions of the original remote control; if not, it is likely that the code found is incorrect, but is used for a very similar device. In that case, repeat the procedure from point 2. If the manual search for the code is successful, obtain the code in use by following the DISPLAY CODE IN USE procedure and make a note of it inside the battery cover. NOTE: During the search the indicator stops flashing and the remote control exits the programming mode in the following cases: • if for 12 seconds the button indicated is not pressed or if another button is pressed • if the list of codes to find is terminated. Com website 8 ENTERING THE CODE DIRECTLY (only to be performed if you know the specific code to be set) 1. Press and hold down for 6 seconds the device selection button corresponding to the device you wish to enter the code for. Immediately enter the specific code previously found. Three long flashes indicate a correct setting. If they do not appear, repeat the procedure. If the result is still negative, it means the code indicated is not included in the remote control. (see following section) INTERNET UPDATE Today you can download from the internet directly to your remote control the codes of the latest devices or those which will be brought out in future, codes which would not otherwise be available using traditional programming methods. To do this you need to purchase the special MELICONI Audiocable, which allows you to download the information you need onto any PC using an internet connection. DISPLAY CODE IN USE If you set up the remote control using the MANUAL SEARCH procedure, obtain and make a note of the code in use as follows: 1. Press and hold down for 6 seconds the device selection button corresponding to the device you wish to enter the code for. Press the TV / RADIO button for an instant. After a pause of several seconds, the indicator light produces four sets of flashes, spaced out, corresponding to the code to be obtained. Each set of flashes corresponds to one figure in the code. Make a note of the code obtained on the label on the inside of the battery cover. [. . . ] Remote control model: Pratico 2 Purchase date Retailer stamp The symbol showing a wheelie bin with a cross through it which appears on the device indicates that at the end of its useful life the product must be collected separately from other waste. Therefore, at the end of the device’s life, you must take it to appropriate centres for the differentiated collection of electrical and electronic waste, or return it to the retailer when purchasing a new device of equivalent type, on a one-for-one basis. Suitable differentiated collection to allow subsequent recycling of the decommissioned device, with environmentally-compatible treatment and disposal, help to prevent any negative effects on the environment and health and to promote the recycling of the materials of which the device is made. Improper disposal of the product by the user will be subject to the sanctions in Legislative Decree No. [. . . ]