User manual MELICONI SPEEDY 110

[. . . ] Keep your Instructions Booklet for future reference. USING THE KEYS AND FUNCTIONS To select the next programme or to turn ON your TV. ON/OFF to turn OFF your TV and, in some cases, to turn ON your TV. Light indicator. Control the volume using -. To select the previous programme or to turn ON your TV. Press them together to turn ON your TV on programme 1. Mute key. To select an external terminal. FITTING THE BATTERIES The remote control requires 2 new AAA/LR03 alkaline batteries. Insert the batteries as shown: · Batteries must be changed once a year. [. . . ] If the commands work incorrectly or erratically, you have probably entered a code for a similar but different remote control. In this case, repeat the search procedure from point 2 until all keys respond correctly to the commands sent. IF YOU DO NOT HAVE THE PROGRAMME SELECTION KEYS ON YOUR ORIGINAL REMOTE CONTROL + If your remote control does not have the programme selection keys (e. g. P / P , +/-, CH+/-. . etc) once you have programmed Speedy 110, you can still select the programmes from 0 to 9, as follows: · Hold down the and keys simultaneously until the light indicator starts to flash indicating that the remote control is in programming mode. + · Release the keys and press P 9 times within 12 seconds. Three flashes indicate that the operation has been completed correctly. + · Make sure you can change programmes from 0 to 9 using the P and P keys. If not, repeat the search operation, starting from point 2. Identify and take note of the TV code which you have searched for, following the code noting procedure (see "PROGRAMMED CODE NOTING" section). NOTE: DURING THE SEARCH OPERATION, THE LIGHT INDICATOR FLASHES MORE QUICKLY. THE LIGHT INDICATOR STOPS FLASHING AND YOUR REMOTE CONTROL LEAVES PROGRAMMING MODE IN THE FOLLOWING CASES: · if no keys are pressed for 12 seconds · if you press keys other than those indicated · if the code search list is completed. In this case, visit www. meliconi. com or contact the call center. PROGRAMMED CODE NOTING When you have programmed Speedy 110 Meliconi, note down the code on the label in the battery compartment cover. To find the code for your remote control: 1. Hold down the and keys simultaneously until the light indicator at the top starts to flash indicating that the remote control is searching for the code. Release the keys and, within 12 seconds, press + P + and P - simultaneously. 3. Release P and P and pay attention to the flashing of the LED: a long flash corresponds to a + while a short flash corresponds to a - . Note the sequence of the 9 flashes and note them down on the label in the battery compartment cover, from left to right. 5 Istr SPEEDY 110+ guscio V4. qxd 12-12-2007 17:09 Pagina 6 RE-PROGRAMMING YOUR REMOTE CONTROL BY ENTERING THE CODE NOTED DOWN If the remote control is no longer programmed because it has been left without batteries for a long time or has flat batteries, you can re-program it quickly as follows: 1. Hold down the and keys simultaneously until the light indicator at the top starts to flash indicating that the remote control is programming. + 2. Release the keys and, within 12 seconds, using the P and P keys, enter the nine-sign code which you noted down before. [. . . ] Replace them. The TV does not respond and the light indicator flashes. Not all remote control commands are working correcting. + You may have used the wrong code. Reset the remote control code, following the programming procedure. The P and P keys do not select the programmes. The original remote control may not have had this + function. [. . . ]