User manual MELICONI SPEEDY 110 FLUO

[. . . ] This note will be handy if you have to reprogram your remote control. SET-UP Read these instructions carefully before programming your remote control!To command your appliances, you must program your Speedy 110 plus as described in paragraphs A or B below. Visit out Internet site www. meliconi. com for interactive instructions for easy and fast remote control programming. [. . . ] If the commands function incorrectly or erratically, you have probably entered a code for a similar but different remote control. In this case, repeat the search procedure from point 3. Identify and take note of the TV code which you have searched for following the code noting procedure (see "PROGRAMMED CODE NOTING" section). NOTE: during the search operation, the light indicator flashes more quickly. The light indicator stops flashing and the remote control leaves the programming mode in the following cases: · if no keys are pressed for 12 seconds · if the code search list is completed. In this case, switch to programming mode B B GLOBAL SEARCH REMOTE CONTROL PROGRAMMING This operation may take a few minutes. 1. Hold down the and keys together until the light indicator at the top starts to flash indicating that the remote control is ready for programming. The light indicator flashes more quickly to indicate that the remote control is ready for the search. Press and release the key slowly several times. Stop when your TV goes OFF (you may have to press the key over a hundred times). When your TV is off, press the been completed correctly. Three long flashes indicate that the operation has Additional check Check that some of the other functions used on your original remote control are working correctly. If the commands function incorrectly or erratically, you have probably entered a code for a similar but different remote control. In this case, repeat the search procedure from point 2. 6 Istruzioni FLUO 17 lingue 11-03-2008 11:47 Pagina 7 Identify and take note of the code which you have searched for following the code noting procedure (see "PROGRAMMED CODE NOTING" section). NOTE: during the search operation, the light indicator flashes more quickly. The light indicator stops flashing and the remote control leaves the programming mode in the following cases: · if no keys are pressed for 12 seconds. · if the code search list is completed. In this case, visit www. meliconi. com PROGRAMMED CODE NOTING Always write down the 4-digit code for your remote control on the label inside the battery cover after running the search and saving the code. This may be useful if you need to reprogram your remote control in the event of accidental cancellation or when you change used batteries. To find the code for your remote control: 1. Release the and and keys until the light indicator at the top starts to flash. [. . . ] If necessary, replace them with 2 new 1. 5 V AAA/LR03 alkaline batteries. Check that the batteries are new and that the remote control is pointing at the appliance without any obstacles in the way. If required, reset the remote control code, following the programming procedure A or B . [. . . ]