User manual MELICONI SPEEDY 210 STB

[. . . ] · Make a note of the code for your TV on the adhesive label supplied inside the battery cover. This note will be handy if you have to reprogram your remote control. SET-UP Read these instructions carefully before programming your remote control!To command your appliances, you must program your Speedy 210 STB as described in paragraphs A or B below. Visit out Internet site www. meliconi. com for interactive instructions for easy and fast remote control programming. [. . . ] In this case, repeat the search procedure from point 3. Identify the code and make a note of it following the code noting procedure (see "PROGRAMMED CODE NOTING" section). NOTE: during the search operation, the light indicator flashes more quickly. The light indicator stops flashing and the remote control leaves the programming mode in the following cases: · if no keys are pressed for 12 seconds · if the code search list is completed. In this case, switch to programming mode B B GLOBAL SEARCH REMOTE CONTROL PROGRAMMING This operation may take a few minutes. 1. Turn on the appliance to be programmed and select a programme. Hold the selection key corresponding to the appliance whose code you are looking for ( or ) down for five seconds until the light indicator at the top starts flashing to indicate that the remote control is programming. The light indicator flashes more quickly to indicate that the remote control is ready for the search. Point the remote control at the appliance. Press and release the key slowly several times. Stop when your appliance goes OFF (you may have to press the key over a hundred times). When the appliance goes off, press the operation has been completed correctly. Three long flashes indicate that the Additional check Check that some of the other functions used on your original remote control are working correctly. If the commands function incorrectly or erratically, you have probably entered a code for a similar but different remote control. In this case, repeat the search procedure from point 2. 6 istr. SPEEDY 210 SB-17 lin 12-12-2007 15:51 Pagina 7 Identify the code and make a note of it following the code noting procedure (see "PROGRAMMED CODE NOTING" section). NOTE: during the search operation, the light indicator flashes more quickly. The light indicator stops flashing and the remote control leaves the programming mode in the following cases: · if no keys are pressed for 12 seconds. · if the code search list is completed. In this case, visit www. meliconi. com PROGRAMMED CODE NOTING Always write down the 4-digit codes for your remote control on the label inside the battery cover after running the search and saving the codes. This may be useful if you need to reprogram your remote control in the event of accidental cancellation. To find the codes for your remote control: 1. Hold the selection key whose code you are looking for down for five seconds until the light indicator at the top starts flashing to indicate that the remote control is programming. [. . . ] If necessary, replace them with 2 new 1. 5 V AAA/LR03 alkaline batteries. Check that the batteries are new and that the remote control is pointing at the appliance without any obstacles in the way. If required, reset the remote control code, following the programming procedure A or B . Change them. When a key is pressed, the light indicator flashes and the appliance does not respond to the commands. [. . . ]