User manual MELITTA EXPRESSO CAFFEO PASSIONE

[. . . ] Danger due to electrical current If the appliance or the power cable is damaged, the risk of a fatal electric shock is run. Observe the following safety instructions to avoid dangers due to electrical current: – Do not use a damaged power cable. € A damaged power cable may only be replaced by the manufacturer, its customer service or a similarly qualified person. € Do not open any covers firmly screwed onto the appliance housing. [. . . ] The water hardness is automatically set to hardness level 1. • Empty and insert the coffee grounds container. After inserting the water filter, the water can be cloudy during the first rinse because excess activated carbon is washed out of the filter. The water will then be clear clear again. Water hardness and filter It is important to properly set the water hardness so that the appliance displays the need to be descaled in due time. from the factory , it is set at water hardness 4. After inserting a Melitta® Claris® water filter, it is automatically set at hardness level 1. Melitta® Claris® water filter The Melitta® Claris® water filter removes lime and other harmful substances from the water. The water filter should be changed every 2 months, however, at the latest when appears on the display. the water filter is available in specialised shops. Inserting the water filter flashes during the entire changing process. € Pull the brewing unit out of the appliance by the handle. € Rinse the brewing unit thoroughly on all sides with clear water. The area shown in Image D (arrow) must be free of coffee residues. € Remove coffee residues from the appliance. € Insert the brewing unit back into the appliance, press and hold the red button (Image B, 1) and turn the handle counterclockwise until the stop. cleaning phase 1 ( ): Two rinsing processes will be performed. Illuminates, proceed as follows: When • Remove and clean the brewing unit („Cleaning the brewing unit“, page 23). € Put a cleaning tab in the brewing unit (Image C). € Insert the brewing unit („Cleaning the brewing unit“, page 23). Cleaning phase 2 ( When ): illuminates, proceed as follows: • Fill the water reservoir with tap water up to the max. Button to continue with • Press the the cleaning programme (takes about 5 minutes). [. . . ] Reglaget längst ut till vänster = 30 ml per kopp Reglaget längst ut till höger = 220 ml per kopp • Tryck på knappen tills den önskade styrkan ställts in. 2015 21:01:17 NO Oversikt Illustrasjon A 1 2 3 4 5 6 7 8 9 10 11 12 13 Dryppskål med koppeplate og grutbeholder samt visning for full dryppskål Høydejusterbart utløp På-/Av-knapp Kaffemengderegulator Knapp for kaffeuttak Knapp for kaffestyrke Vannbeholder Bønnebeholder Knapp for damputtak Display Ventil til damp- og varmtvannsporsjon Damprør Høyre tildekning (avtakbart, bak dette justering for malegrad, bryggeenhet og typeskilt) Display lyser blinker lyser blinker lyser blinker lyser blinker lyser Apparatet er driftsklart Apparatet varmes opp eller kaffeuttak pågår Bytte Melitta® Claris®vannfilter Filterskifte pågår Fyll vannbeholderen. € Trykk knappen , for å vise menyen for innstilling av vannhardheten. € Aparatul poate fi utilizat de copii începând cu vârsta de 8 ani şi de persoane cu capacităţi fizice, senzoriale sau mentale reduse sau care nu deţin experienţa şi/ sau cunoştinţele necesare, dacă sunt supravegheate sau dacă au fost instruite referitor la utilizarea sigură a dispozitivului şi dacă au înţeles pericolele care rezultă de aici. [. . . ]