User manual MELITTA VARIANZA CSP

[. . . ] 5 Switching on the appliance for the first time. 4 Filling coffee beans into the bean container. 8 Emptying the drip tray and coffee grounds container. 1 Filling with coffee beans for the My Bean Select® function. [. . . ] Changing beverage settings during preparation The beverage quantity and the coffee strength can be changed during beverage preparation. During beverage dispensing, use the arrow buttons to set the relevant beverage amount. During the grinding process, use the "Coffee strength" button to set the coffee strength. The "Two cups" button is used to prepare two beverages simultaneously. Two-cup dispensing is only possible with pure coffee dispensing, such as Espresso, Café Crème, Ristretto. Two-cup dispensing is not possible with the preparation of hot water, hot milk and all mixed beverages. Place two vessels beneath the outlet (6). Continue as described for preparation of the relevant beverage. Information The setting only applies to a single beverage that is prepared. If a beverage is not prepared within 1 minute, the appliance switches to The appliance offers further options for preparing coffee specialities. Default recipes can be used or the beverage settings can be permanently changed. Depending on the beverage, the following default settings can be changed: Coffee amount: 25 ml to 220 ml Milk amount or milk froth amount: 25 ml to 220 ml Hot water amount: 25 ml to 220 ml Coffee strength: Very mild, mild, normal, strong, very strong Temperature: Low, normal, high Information Changed default settings remain valid until they are changed again. Changing the beverage settings is similar for all beverages. Changing the coffee strength for an Espresso is described here as an example. Direct keys Espresso Coffee strength Strong Confirm with OK: fig. 17: Setting the coffee strength Requirement: The ready symbol appears on the display. Press the "menu/ok" button for longer than 2 seconds. Navigate to the Direct keys > Espresso > Coffee strength menu. Use the arrow buttons to select the desired coffee strength and confirm Repeatedly select the Exit command to exit the menu. ?» The ready symbol appears on the display. ?» The newly selected coffee strength is used the next time an Espresso is Operating steps that change the appliance's basic settings are described in the following chapter. Requirement: The ready symbol appears on the display. [. . . ] Re-adjust the water hardness if necessary, (see section 9. If the actions listed below fail to rectify the problems or other problems not listed here occur, contact our hotline (local rate). Appliance is covered Descale the appliance (see secinside with limescale. Water tank not filled Fill the water tank and ensure it is Clean the brewing unit (see section 9. [. . . ]