User manual MEMOREX MB2059A

[. . . ] · Consult the dealer or an experienced radio/TV technician for help. 1 LOCATION OF INDICATORS L K J I R DATE REMAIN A B C D AB LP MP SP HP C REPEAT ALL D E F G H A. L. Play Indicator Recording Quality Indicators Message/Year Indicators REPEAT 1/ALL Indicators Record Indicator Battery Indicator Date/Volume Indicators Minute/Second (Timer) Indicators REMAIN Indicator R (Record) DATE Indicator VOX Indicator Message File Folder Indicator 2 LOCATION OF CONTROLS FRONT 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 1. 8. MIC (Microphone) Jack Built-in Microphone Display REV Button MODE/PAUSE Button PLAY/STOP Button REC/STOP Button Speaker 9. 12. EAR (Earphone) Jack REC Indicator VOLUME Up Button VOLUME Down Button 13. [. . . ] You can store a total of 200 messages or 925 minutes in LP mode (695 min. 99 messages are the limit for each file folder. To select a file folder: 1 2 1 Press the REC/STOP 1 or PLAY/STOP 2 button to enter the Standby mode. Press the FILE/TIME button 3 to select the desired file folder (A, B, C, D). The number at the top right of the display indicates the total messages recorded. The number at the bottom of the display will indicate the time recorded for the selected message. NOTE: 3 Each time you record a message, the unit will assign a number, counting up 1 from the last message number, which will be shown on the display. If the unit is full, FULL will appear in the display. Delete messages in this case. 3 13 OPERATION RECORDING SENSITIVITY 1 Slide the MIC SENS switch to the LOW position if recording sounds that are close. Select the HIGH position if recording sounds that are further away. HOLD SWITCH 1 1 Slide the HOLD switch to the LOCK position to disable the buttons; HOLD will appear in the display if the unit is in the Standby mode. Slide the HOLD switch to the OFF position to enable the buttons again. 14 OPERATION NORMAL RECORDING This unit is capable of recording only when sound is heard. For normal recording, follow steps below. 1 Make sure the VOX switch on the rear of unit is set to OFF. Turn the unit on (by pressing the REC/STOP or PLAY/STOP button) and select the desired sound quality as previously described. 2 1 2 1 Select a File Folder as described on page 13 by pressing the FILE/TIME button 1. While in the Standby mode, press the REC/STOP button 2 and the REC indicator will light and the elapsed time will appear. 15 OPERATION 3 Speak into the built-in microphone or insert a microphone into the MIC jack and speak into it in a normal tone of voice. Press the REC/STOP button again to stop recording. 4 3 1 2 Press and hold the PLAY/STOP button 1 to see the remaining recording time during recording. To pause recording, press the MODE/PAUSE button 2; PAUSE will blink in the display. To release pause, press the MODE/PAUSE button 2 again. NOTES: · The built-in audio level automatically sets the recording level. · For normal voice levels, a distance of 5-9 inches is appropriate. 3 16 OPERATION VOICE ACTIVATED (VOX) RECORDING Voice activated recording will allow dictation only when you speak. When the unit detects a pause of a few seconds, it will temporarily stop recording until it detects sound again. 1 Slide the VOX switch on the rear of the unit to the ON position. [. . . ] Extreme temperatures can shorten the life of electronic devices, damage batteries and/or melt plastic parts. · Keep the unit away from dirt and dust. · Handle the unit gently and carefully. Dropping it can cause damage and may cause the unit to work improperly. [. . . ]