User manual MEMUP SATELYTE

[. . . ] Do not obstruct the ventilation by a newspaper, a tablecloth and a curtain, etc. Do not install the appliance near the sources of heating, such as a heating fan, a stove or a radiator. Exposure to temperatures higher than 170 F (for example, the inside of a closed car in summer time) may damage the appliance. Do not place any naked flame sources, such as lighted candles, on the device. [. . . ] Pull out the L&R cables of the speaker hub and insert them into the jack of the Satelyte speakers and then install the speaker system. Slightly pull out the L&R cables and push them inward so that they can get inside. *Warning: If you pull out the speaker wire too hard, it may damage the wire and result in no sound. - Please connect Speaker System and MP3 Player through LINE IN CABLE. *Warning: Turn-off Power when you insert MP3 Player to the speaker system. Adjust MP3 Player's Volume Level as 70%-80% out of its Max Power. If you playback it with excessively higher or lower volume, the quality of the sound may decrease sharply and damage the device. * Insert the adaptor supplied with the appliance into AC outlet and insert the power output terminal of the adaptor in the DC in the jack of the appliance. Use only the adaptor supplied together with the appliance when shipped out of factory. Charging: When you connect the adaptor, the MP3 Player starts to charge automatically. Play and charging cannot be done at the same time. Put AA type, 1. 5V 4EAs into the battery cavity. Insert them one by one as the picture below shows. Take care to ensure the correct polarity of batteries when you insert them. Warning: Batteries drain even when you do not use the appliance. Take out the batteries when you are not using the speaker system. *Use only Alkaline Battery ("AA"). If you do not use Alkaline Battery, it might negatively affect on speaker system. POWER LED When you power up, Power LED lights up. WIDE Switch WIDE on when you want a magnificent surround sound (sound in three dimensions) effect Note: Aforementioned effect (surround effect) has a different formation from general 3D sound because it is a circuit specially designed and manufactured by our company. VOLUME Turn the master volume to (+) when you want to increase volume. Turn the master volume to (-) when you want to decrease volume. X-BASS Switch VOLUME on when you want to reinforce low sound. POWER SWITCH If you put POWER SWITCH on, Power LED lights up and then Speaker System works. [. . . ] Check if the 3. 5mm stereo cable is connected to another jack, not to the headphone output jack. Separate the 3. 5mm stereo cable froma portable MP3 player and connect it to other appliances (portable CD players, cassette players and radio) and then check the speaker. Turn the volume of the speaker system to (-). The speaker with a high output of power reveals the distortion and unclean sound easily when the files in WMA or MP3 players do not have a good quality. [. . . ]