User manual MERCURY MARINE SMARTCRAFT

[. . . ] Systems Monitor Operation Manual THIS MANUAL DESCRIBES THE SMARTCRAFT GAUGE SYSTEMS AVAILABLE FOR YOUR BOAT 2004, Mercury Marine 90-895202 204 0 TABLE OF CONTENTS Legend . 4 Initial Power Up (Or After Master Reset) . 22 NOTE:This manual shows all the Monitor display screens that are available. Depending on your type of engine, not all these screens will apply. 1 2 LEGEND A= B= C= D= E= F= I= L= N= O= P= S= T= U= = Engine = Fuel = Water Temperature = Water Pressure = Oil = Alarm 3 BASIC OPERATION The Monitor is an LCD multi-function display gauge. [. . . ] Press the button to select. button to move to the next function. 14 CAL 1 CALIBRATION Trim Trim Sensor 0. 0 Setting (Full Trim in Position) 1. The word "Trim" and down arrow should be blinking. button to advance to 10. 0 setting. Trim Sensor 10. 0 Setting (Full Trim Out Position) 5. The word "Trim" and down and up arrows should be blinking. Trim unit out to the maximum trim (not trailer) position. button to advance to 25. 0 setting. Trim Sensor 25. 0 Setting (Full Trailer Out Position) 9. The word "Trim" and up arrow should be blinking. Use the trim switch and trim unit out to the maximum trailer position. button to move to the next function. 15 CAL 1 CALIBRATION SAE English System F Psi Ft Metric System C Bar Ltr M English or Metric Gal Select whether you want the readings in the SAE English system or the Metric system. 1. Press the Range button to toggle between units. button to move to the next function. Range Readings Miles NMiles Km Miles Select whether you want the readings in Miles, Nautical Miles or Kilometers. 1. Press the button to toggle between units. button to move to the next function. Depth Display (on or off) Select whether you want the depth screen to be displayed. Trim Trim Display (on or off) Select whether you want the trim screen to be displayed. 1. Press the button to select on or off. button to move to the next function. 16 CAL 1 CALIBRATION Coolant Temperature Display (on or off) Select whether you want the coolant temperature screen to be displayed. button to move to the next function. Oil Pressure Display (on or off) Select whether you want the oil pressure screen to be displayed. NOTE:Press and hold and the CAL 2 calibration screen. for 3 seconds to get out of Cal 2 Start Screen Press the button to move to the next calibration screen. Pitot Water Pressure Sensor Input Select the pressure input of the Pitot water pressure sensor on the engine. NOTE:The standard speed input on production Mercury Outboards is 100 PSI. Certain High Performance applications may require a 200 PSI input. Press the 0 =No Pitot pressure sensor 1 = 100 PSI 2 = 200 PSI 2. [. . . ] button to ad- 25 CAL 2 CALIBRATION Tank 2 Calibration Select whether you want to calibrate tank 2. NOTE: Tank 2 does not have to be a fuel tank. It could represent an oil tank for example. NOTE: The gauge will not let you calibrate the tank until the capacity had been entered). [. . . ]