User manual METABO POWERMAXX12

[. . . ] Keep all safety instructions and information for future reference. Before using the power tool, carefully read through and familiarise yourself with all the enclosed safety information and the Operating Instructions. Keep all enclosed documentation for future reference, and pass on your power tool only together with this documentation. 4 Special Safety Instructions F For your own protection and for the protection of your power tool, pay attention to all parts of the text that are marked with this symbol! [. . . ] A warning signal sounds (continuous beeping). The beeping stops after a maximum of 30 seconds or when the trigger is released (6). Battery pack almost flat (the electronics prevent the battery pack from discharging totally and avoid irreparable damage). If the battery pack is almost flat, it must be recharged. Long continuous overloading of the machine will activate the temperature cut-out. Leave the machine or battery pack to cool. Note: The machine will cool more quickly if you operate it at idling speed. If the current is too high (for example, if the machine seizes continuously for long periods), the machine switches off. Switch off the machine at the trigger (6). Try to prevent the machine from seizing. 1 2 3 4 5 6 7 8 Protective cap/bit clamping bush* LED lights Adjusting sleeve (torque control, maximum torque) Slide-switch (1st/2nd gear) Rotation selector switch (direction of rotation setting, transporting safety device) Trigger Battery pack release button Battery pack Charge the battery pack before use. if performance diminishes , recharge the battery pack. The ideal storage temperature is between 10°C and 40°C. Removing the battery pack Press the battery pack release (7) button and remove the battery pack (8). To fit Slide in the battery back (8) until it engages . 3 Setting the direction of rotation, engaging the transporting safety device (switch-on lock) Do not activate rotation selector switch (5) unless the motor has completely stopped!Actuate the rotation selector switch (direction of rotation setting, transporting safety device) (5). 4 Selecting gear stage 1st gear (low speed, particularly high speed, preferable for screwing) 2nd gear (high speed, preferable for drilling) 7. 5 Setting torque control, drilling ENG Screws in areas that are hard to access The angle screwdriver attachment (see Accessories chapter) greatly facilitates work on areas that are difficult to access. If you need any accessories, check with your dealer. For dealers to select the correct accessory, they need to know the exact model designation of your power tool. Screw the quick-clamping chuck onto the spindle thread. [. . . ] However, if the tool is used for other applications, with different accessories or is poorly maintained, the vibration level may vary. This can considerably increase the vibratory load over the entire working period. An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This can considerably reduce the vibratory load over the entire working period. [. . . ]