User manual METABO STEB 70 QUICK

[. . . ] - To extract dust more efficiently, use the protective cap (9) and a suitable Metabo vacuum cleaner together with this tool. - The work place must be well ventilated. - The use of a dust mask of filter class P2 is recommended. Follow national requirements for the materials you want to work with. [. . . ] - Insert the saw blade (3) up to the stop. Ensure that the saw teeth are facing forwards and the blade is seated correctly in the groove on the saw blade support roller (2). - Push back the clamping lever (1) to its original position (the saw blade is now clamped securely in position). 3 Attaching / Removing the protective cap Attachment: Push on the protective cap (9) from the front until it engages Removal: Grip both sides of the protective cap (9), lift slightly, then pull forwards and remove. 4 Sawing with dust extraction - Connect a suitable extraction device to the extractor connection piece (16). Use a suction hose with a 30 mm connector diameter. - Attach the protective cap (9) for maximum extraction efficiency. 5 Sawing without dust extraction - Work with the protective cap (9) removed (see Removal chapter 6. These parts cannot be used for diagonal cuts. - Then slide the footplate (5) forwards or backwards and engage in one of the detents (the detents can be viewed through the semicircular opening at the rear of the footplate (5). ) The preset angle is indicated on the curved support plate (17) on the footplate. Adjust to different angles using an angle gage. 7 Sawing close to the wall Remove the protective cap (9), anti-splintering footplate insert (8), circular-cutting and parallel guide. These parts cannot be used when sawing close to the wall. - Slacken the screw (4) until the footplate (5) can be raised slightly. - Raise the footplate (5) slightly and slide backwards up to the stop. 1 Chip blower Optional blower for a clear view of the cutting line. On: press in the switch button (6) on the right side of the machine. Off: press in the switch button (6) on the left side of the machine. 2 Adjusting the pendulum motion Set the required pendulum motion using the adjustment lever (7). The best way to determine the ideal setting is through a practical trial. 3 Setting maximum speed Set the machine to maximum speed using the setting wheel (12). [. . . ] 11 en ENGLISH Emission values These values make it possible to assess the emissions from the power tool and to compare different power tools. Depending on the operating conditions, the condition of the power tool or the accessories, the actual load may be higher or lower. For assessment purposes, please allow for breaks and periods when the load is lower. Based on the adjusted estimates, arrange protective measures for the user e. [. . . ]