User manual METRONIC DINTERIEUR AMARINNE

[. . . ] Installation in premises which are confined or subject to temperature or dampness changes (sheds, attics, cellars, tiny rooms, dry risers etc. ) may cause an overheating of the device or a premature ageing resulting in failures that are not covered by the guarantee. Never open the receiver even when it is not connected, because it contains electrical components, which can be dangerous for you. In general, electrical appliances are not earthed, so you can get electrical discharges (which are not risky), while implementing the connections. Our advice is to connect the equipment after all the sockets connections have been made. [. . . ] Go in MENU / Installation / Program Satellite. On the Number of Antenna line, select the number with 34 arrows (for example 2 for a monoblock). On the Current Antenna line, select 1 with 34 arrows. On the Satellite line, select with 34 arrows the satellite for which you affect the number 1 (for example Hotbird). If you receive more than one satellite, go back to step 1 and redo the same steps for the other satellites (for example, 2 = Astra1, . . . ) Press EXIT to quit the menus B - Manual shearch A channel is transmitted by something called a transponder (TP). It is a satellite relay of which you must know the 4 technical parameters: · · · · The The The The frequency (eg 12551 MHz) Symbol Rate (eg 22000) polarity (eg Vertical) satellite that carries this TP (eg Hotbird) You will find these parameters in specialized magazines, or in dedicated websites (www. satcodx. com or www. lyngsat. com for example). 20 · Go in MENU / Installation / Program Satellite · On the Current Antenna line, select with 34 arrows the number that makes the correct satellite appear on the Satellite Name line. · On the TP line, press OK to show the TP list window (Freq, Pol, SR) · With 34 and 56 arrows, select the relevant TP. If the TP is not listed, you must add it as explained in the next section. · Press OK and check that the signal is correct (Signal Quality >50%). Should the opposite occur, you will have to check again the technical parameters, or check the DiSEqC settings in the LNB setup menu. · On the Search Type line, select TP with 34 arrows. To modify a transponder · · · · · · Put first the selection bar on the TP you want to modify. Press the green key, the Edit window pops up. Enter the 5 figures of the frenquency and press 6 Select the polarity with 34 arrows and press 6 Enter the 5 figures of the Symbol Rate and press 6 Press OK on the Store line to save this new TP. E - Shearch of a particular channel (PID entry) In some (rare) cases, a manual or automatic search may not find a channel that does exists however. You must then add this channel by entering the PID's that you will find in specialized magazines or websites : 22 · · · · · · · · · · · · · · Go in MENU / Edit / Edit CH. Press the yellow key, the Add channel pops up. On the Satellite line, select the satellite with 34 arrows. On the TP line, select with 34 arrows the TP that carries the channel to add. If the TP is not listed, you must add it in the Edit TP menu as explained above in this manual. On the Channel line, press OK to display the window allowing to edit the channel name. To write a letter at the cursor location, press the 0-9 keys as you would do with a cellular mobile phone (for example, press twice the key 3 to write a E). Press the 4 arrow to edit the next letter, press one of the color keys to insert or delete a letter. [. . . ] Type of broadcast signal used in modern transmissions. It uses up less space than analogue broadcasting in the spectrum. Digital television can carry more channels in the same amount of bandwidth than analogue television ever could. Cable and satellite TV has already been using digital channels for a few years. [. . . ]