User manual METRONIC DINTERIEUR CLIPSEA

[. . . ] The frequency of the RF signal used to carry the audio-video information is the same as the frequency used by microwave ovens and other wireless transmissions such as Wi-Fi. The frequency used for the remote extension is also used by miscellaneous wireless equipments like alarm systems and many home appliances. In case of malfunction, try to switch OFF the other wireless equipments. If someone in your neighbourhood uses the same video sender, it may interfere with yours. [. . . ] As soon as you stop using the video sender, you have the legal responsibility to switch off the transmitter by pressing the power button on the front panel. Generally, the video senders dont feature any tuner. So, if your satellite receiver is tuned on a given channel, you may not watch another satellite channel on the secondary TV. However, thanks to its fully independent switching matrix, This multi-sources video sender allows to watch any source on the distant TV and any other source on the main TV. Each remote control need a AA battery (not provided). In respect of both the environment and the law, dont throw the used batteries in the bin. Bring them back instead in the shop where you should find a container for recycling. In case of thunderstorm, disconnect all your equipments from the mains, they might suffer from damages not covered by the warranty. 0 208 994 11 81 3 3 A INSTALLATION Setting up the transmitter 1 - Install the batteries in the remote controllers taking care of not inverting the polarity. 2 - Unplug all the scart leads connected to the main TV and hook them up to the relevant socket of the transmitter. It may happen that several devices use the same scart lead. For example, a scart lead may run from the VCR to the SAT receiver, and from SAT receiver to TV. In that case, leave the first link between VCR and SAT, and plug only on the transmitter the scart from the SAT receiver. So, we advise you to use the serial connection for devices featuring a VCR scart. For example, you can connect your VCR on your TV by passing through the satellite receiver. This serial wiring (example with 3 devices) is shown on the picture below : You must be aware that - The picture quality worsens each time a device is passed through. You should then use this technique for 2 or 3 devices only. - To let the signal pass, some devices may required to be switched on. 0 208 994 11 81 7 3 5 HOW TO USE To watch a source (DVD, SAT, VCR) on the main TV, switch on the main TV and force the AV mode, the screen should be black. Switch on the source in question on and press the relevant key on the 8-buttons (PRI) remote control. The picture and sound are now available on the main TV, and the related LED lights red. If its orange, it means that source is also sent to the receiver. If you dont have the remote control to the hand (or in case of the batteries are worn-out), you can use the buttons located on the transmitter. Press the PRI/SEC button until it lights red and press the button for the source. To watch a source (DVD, SAT, VCR) on the secondary TV, switch on the source and the secondary TV. [. . . ] Press the PRI/SEC button until it lights red and press the button for the source. To watch a source (DVD, SAT, VCR) on the secondary TV, switch on the source and the secondary TV. Force the AV mode on the secondary TV and select the source with the 4buttons remote control. The picture and sound are now available on the secondary TV. [. . . ]