User manual METRONIC DINTERIEUR SLIMTECH DESIGN

[. . . ] Installation in premises which are confined or subject to temperature or dampness changes (sheds, attics, cellars, tiny rooms, dry risers etc. ) may cause an overheating of the device or a premature ageing resulting in failures that are not covered by the guarantee. Never open the receiver even when it is not connected, because it contains electrical components, which can be dangerous for you. In general, electrical appliances are not earthed, so you can get electrical discharges (which are not risky), while implementing the connections. Our advice is to connect the equipment after all the sockets connections have been made. [. . . ] · Store (7) , make the motor turn to the position founded. · Check that you receive the Astra channel. If not, it means that you stored the position of another satellite, which broadcasts some channels at the same frequency. Try the operation above again and make sure that your satellite dish is pointed slightly on the left from Hotbird like shown on the Diagram M below. Do the same operations for the other satellites. When you receive all the satellites, screw definitively all the nuts. Your installation is finished. @Note : The Hispasat or Turksat reception with a motorised installation is very difficult and needs a perfect alignment. For the reception of this satellite, we advise a fixed installation, with a particular look at the adjusting of the counter-polarization. Reminder : Atlantic Bird 3 = ex Télécom 2C Astra 19 Eutelsat W2 Atlantic Bird 3 Hotbird Eutelsat W1 Eutelsat W3 M Astra 28 Turksat Weak satellites Medium satellites Strong satellites (1)(2)(4)(5)(6)(7) see related paragraph page 13 22 (Astra 2) Arabsat Hispasat (Astra 1) N - Adjustment of the electronic limits Adjustment of the East limit · Press the black key to access the Motor Setup menu · Go to the line Move, press and hold the 3 arrow key to drive the motor East and get ready to press the key OK when the border of the dish reaches the obstacle. · Go to the line Set Limit, and select East Limit with 3 arrow key · Press OK to set the East limit and confirm with OK. Adjustment of the West limit · Press the black key to access the Motor Setup menu · Go to the line Move, press and hold the 4 arrow key to drive the motor West and get ready to press the key OK when the border of the dish reaches the obstacle. · Go to the line Set Limit, and select West Limit with3 arrow key · Press OK to set the East limit and confirm with OK. 5 - Connection to an already installed dish The receiver being disconnected from the mains, connect directly the LNB to the LNB receiver input. Connect a scart lead from the television to the receiver TV output scart socket. In programming mode, this key is used to alter the value of a setting. In viewing mode, press these keys to change 5 channels. In the menus, press these keys to highlight the next or 7 previous item. In viewing mode, gives access to the channel list. In 17 programming mode, press OK to access to the submenu related to 18 the currently highlighted item. Press this key to exit all menus and come back in viewing 20 mode. If broadcast by the operator, shows information about the current programme and the following programme. Press OK to select the program you want to watch. If more than one audio language is being broadcast, this key allows you to show all the available languages. 14 2 3 1 8 15 5 4 6 4 5 16 10 6 13 9 7 8 9 10 11 FAV key. Display information about the channel you are currently watching. [. . . ] The channel you want to watch is probably scrambled. For your information, an operator can broadcast a scrambled channel with information that lets believe the receiver that the channel is free. The opposite situation is also possible. Beware: A channel can be free for a certain period in the day, and pay-TV in other periods. · The terminal asks me a PIN code to watch a channel. [. . . ]