User manual METRONIC TOUCHBOX 2

[. . . ] Digital Satellite Receiver 3500 channels Parental Control 2 Scarts DiSEqC 1. 2 Timer SIGNAL MET447 CAUTION Your TouchBOX 2 has ventilation slots. These slots must not be obstructed, even partially, in order to ensure proper ventilation. The lifetime and normal functioning of your device depends on these factors. Installation in premises which are confined or subject to temperature or dampness changes (sheds, attics, cellars, tiny rooms, dry risers etc. ) may cause an overheating of the device or a premature ageing resulting in failures that are not covered by the guarantee. [. . . ] It is useful to know on which inputs of the switch the heads Astra and Hotbird are connected. If you do not know it and that the installation is difficult to reach, test the 2 possible combinations: Astra on A (or 1) and HotBird on B (or 2) or the opposite. To program your receiver, follow the instructions from paragraph 3B page 12. Caution: you should not touch the satellite dish adjustments nor to the switch, it is only necessary to program your digital receiver. schema monobloc DiSEqC switch1. 0 or Tone Burst DiSEqC1. 2 DiSEqC1. 2 13/18 V 500 mA DEMO LNB TV VCR / S/PDIF 13/18 V 500 mA DEMO LNB TV VCR / S/PDIF TouchBOX2 back Coaxial cable Scart lead www. metronic. com 25 7 - Connection on a motorised DiSEqC 1. 2 already aligned Connect the cables and the leads as indicated on the figures below. When 2 satellite receivers (a digital and an analogue receiver for example) control the same motor, it is important that each one of them give the same number to a given satellite. For an easiest installation of your new digital receiver, locate the classification of the satellites used by your analogue receiver. If your motor and your receiver have never been used before, use the number that you wish for each satellite. OU DiSEqC1. 2 13/18 V 500 mA DEMO LNB TV VCR / S/PDIF TouchBOX2 back Arrière Analogique DiSEqC1. 2 13/18 V 500 mA DEMO LNB TV VCR / S/PDIF TouchBOX2 back Arrière Analogique Coaxial cable Scart lead figure 5 Coaxial cable Scart lead If you do not have an analogue demodulator, connect directly the receiver to the television. For each satellite you want to receive in digital, it is necessary to proceed as follows: Example on HotBird · Go in MENU / Installation / Antenna type. · On the line LNB dish, choose Moved with the key 34 26 www. metronic. com For each satellite, you will go onto the reference channel (see table 1 page 9) then give a number to this satellite. For that: · Go into MENU / Installation / Channel Setup · On the line Satellite Number, choose the number with the arrows 34. If the number that you are giving is already taken, an alert message is appearing 3 seconds at the bottom of the screen. · Press on OK to give a number to a satellite and then wait until the motor stops moving. · If your motor was correctly aligned, and that you have entered the right number for HotBird, the signal indicator must be green. If it is not the case, check the alignment and your satellite numeration with your analogue receiver, if you have one. · Press on EXIT to leave all the menus and check that you effectively receive the channel from the satellite in question. · Do the same thing for the other satellites. www. metronic. com 27 8 - Remote control description 1 Digital keys. In normal use, it allows to type the channel number desired. In the programming mode, that allows to enter the digital values. Allows switching on or switching off and putting the terminal in standby. Allow you to enter in the main menu or to leave the main menus. 3VOL4 key makes it possible to regulate the volume on a normal use. In the menu, allow you to modify various parameters. Gives you the ability, as well, to display the following page (4) or the preceding page (3) in the long list. [. . . ] · Do you think the user manual is user friendly when you have to install, without an installer, a satellite kit?yes no Which modifications would you wish to see? · Where did you install your satellite kit ?On a balcony On the roof (chimney. . . ) On the wall On the ground Other. . . . . . . . . . . . . · Which cable lenght did you use ? [. . . ]