User manual METZ MECABLITZ 48 AF-1 PENTAX

[. . . ] Zoom automatique En cas d'utilisation du flash avec un appareil photo qui transmet des données concernant la distance focale de l'objectif, la position du zoom du réflecteur principal s'adapte automatiquement à cette distance focale. - Lorsque «S ON» s'affiche à l'écran, la fonction « zoom size » est activée - Lorsque «S OFF» s'affiche à l'écran, la fonction « zoom size » est désactivée. 87 Table 1: Guide numbers at maximum light output (P 1/1) . 132 Table 3: Recycling times and number of flashes with different battery types . [. . . ]  The return from manual zoom mode to auto-zoom mode also occurs if the flash unit is switched on again with the main switch . wide-angle diffuser With the wide angle diffuser , focal lengths of 18 mm or more can be illuminated (35 mm format). Pull the wide-angle diffuser out from the main reflector as far as it will go, and then release it. The distance readings and the zoom value are corrected to 18 mm on the display panel. To insert the wide-angle diffuser , turn it upwards 90° and push it all the way in. The distance data and zoom factor are corrected to 16 mm. With the remote slave mode activated, press the button combination , , Select" until , , CH" (= remote channel) flashes in the display. After about 5 seconds the display stops flashing and the setting is saved automatically. Use flash unit mounting foot W-F127 to set up the slave flash unit. When the slave flash unit is flash-ready, the AF measuring flash also flashes . Manual flash exposure correction in slave operation A manual flash exposure correction of can be set from ­3 to +3 stops (EV) in 1/3 increments on the slave flash unit in the remote mode (see also 8). setting procedure · Press key combination "Select" repeatedly until "EV" flashes in the display. Using the keys ( + ) and ( - ) set the desired correction value. The setting is immediately effective and is automatically saved after approx. To deactivate the flash exposure correction, delete the setting of the correction value using the keys ( + ) and ( - ).  The same remote channel must be set on the slave flash unit as on the At the same time, one or more slave flash units can be remotely controlled from one master or controller flash unit on the camera (e. So that multiple remote systems in the same room do not interfere with one another, there are four independent remote channels available (CH 1, 2, 3 or 4). Master, controller and slave flash units belonging to the same remote system must be set to the same remote channel. The slave flash units must be able to receive the light from the master or controller flash unit with the integrated sensors for the remote mode .  Depending on the camera model, the camera's internal flash unit can also function as master or controller flash unit. Please consult the respective camera operating instructions for further tips on setting the master or controller flash unit. After about 5 seconds the display stops flashing and the setting is saved automatically. [. . . ] No data exchange took place between the flash unit and camera. The internal camera flash or the external flash unit (mecablitz) is not flash-ready. Guide numbers at ISO 100/21°, zoom 105 mm: In the metric system: 48 In the imperial system: 157 Flash modes: Standard TTL without measuring preflash, P-TTL, P-TTL HSS, Manuell M. 460 with lithium batteries (at full light output) Recycling time (at full light output): Approx. [. . . ]