User manual METZ MECABLITZ 48 AF-1 SONY

[. . . ] Zoom automatique En cas d'utilisation du flash avec un appareil photo qui transmet des données concernant la distance focale de l'objectif, la position du zoom du réflecteur principal s'adapte automatiquement à cette distance focale. Mode zoom manuel Avec les appareils photo qui ne transmettent pas de données concernant la distance focale de l'objectif, vous devez adapter manuellement la position du zoom du réflecteur principal à cette distance focale. 79 Table 1: Guide numbers at maximum light output (P 1) . 118 Table 3: Recycling times and number of flashes with different battery types . [. . . ] wide-angle diffuser With the wide angle diffuser , focal lengths of 18 mm or more can be illuminated (35 mm format). Pull the wide-angle diffuser out from the main reflector as far as it will go, and then release it. The distance readings and the zoom value are corrected to 18 mm on the display panel. To insert the wide-angle diffuser , turn it upwards 90° and push it all the way in. mecabounce 58-90 If the Mecabounce 58-90 (optional accessories , see 17) is fitted to the main reflector of the flash unit , the main reflector is automatically guided to the position required. The distance data and zoom factor are corrected to 16 mm. The flash unit supports the wireless Sony Remote System in slave flash operation, whereby one or more slave flash units can be remotely controlled in a wireless manner via the camera's integrated flash unit functioning as a controller flash unit. In so doing, the flash of the controller flash unit only has a control function for the slave flash unit and is not itself involved in the exposure of the given shot. The slave flash units must be able to receive the light from the controller flash unit via their integrated sensor for remote operation . Fold the camera's integrated flash unit (controller flash unit) in fully and fit flash unit (mecablitz 48AF-1 digital) to the camera (see 3. Actuate the camera's shutter release so that a data transfer occurs between the camera and the flash unit, whereby the flash unit is automatically set to remote slave flash operation. With the flash unit fitted to the camera, deactivate wireless remote flash operation ("Wireless" or "WL") or set normal flash operation. Actuate the camera's shutter release so that a data transfer occurs between the camera and the flash unit, whereby the flash unit is automatically set to normal flash operation. the indicator SL is then deleted on the flash unit's display. Remote slave flash operation can also be activated and deactivated without the camera (option 2) · press the "Select" button repeatedly until SL flashes on the display. Use the ( + ) and ( - ) buttons to make the required setting. 5 seconds the indicator stops flashing and the setting is memorised automatically. To this end, press the "Mode" button repeatedly until the symbol for the required remote operating mode TTL or M flashes. 5 seconds the indicator stops flashing and the setting is memorised automatically.  In remote flash operating mode "SL" , high-speed synchronisation HSS (TTL HSS or M HSS) cannot be set via the slave flash unit. High-speed synchronisation is automatically activated via the slave flash unit when flashing for the duration of the shot concerned if a shutter time less than the camera's high-speed sync time is set on the cameral (see camera operating instructions)!Shorter shutter times than the flash sync time can only be set on the camera in remote operation if the slave flash unit is not fitted to the camera and the camera is set to the remote operating mode "WL" (wireless). [. . . ] Tilt the main reflector downwards or turn the wide-angle diffuser in front of the reflector. The subject is beyond the range of the flash unit. The subject contains very bright or highly reflective areas. In close-up shots, overexposure (shots that are too bright) may result if the shutter speed is faster than the flash sync speed. [. . . ]