User manual MICROTEK 515M

[. . . ] USER'S MANUAL FCC Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. [. . . ] · DO NOT place your LCD monitor near a window as it may be severely damaged if exposed to rain, water, moisture, or sunlight. · MAINTAIN good ventilation; covering of ventilation slots or holes may cause fire. · PLACE the monitor at least 4 inches (or 10 cm) away from the walls · SAFE storage temperature of the LCD monitor is in a range of ­4ºF to +149ºF (-20ºC to +65ºC). 4 Connecting the Monitor Warning: Do not operate the LCD monitor with unspecified power supply. Usage of incorrect voltage will cause malfunction and may cause fire or electric shock. Use the VGA cable to connect the VGA connector of the LCD monitor to the VGA port of the computer. Make sure the cables are securely connected. Plug the DC connector of the adapter to your monitor's DC jack. Plug the female end of the power cord into the AC adapter. Connect the male end of the power cord into a wall socket. Turn on your computer, and then turn on your LCD monitor. VGA Cable: Connect with VGA cable. Power: Plug into the AC power adapter. AC/DC Adapter VGA cable Power cord Note: For added protection, the use of a Surge Protection device is recommended. The Surge Protection device should be installed between the AC Adapter and the electrical wall outlet to prevent the effects of sudden current variations from reaching and damaging the LCD monitor. 5 Adjusting the Viewing Angle Your LCD monitor is designed to allow adjustment for optimal viewing angles. You can adjust the monitor upward to 35 degrees and downward to -5 degrees. Note: Do not touch the screen while changing the viewing angle, as this may damage the screen. In addition, make sure your fingers do not get caught in any of the monitor's parts while adjusting the viewing angle. 6 Operating the Monitor The LCD monitor has been preset at the factory with the Timing shown in the section "Appendix B" to achieve optimal display. You can adjust the display to the desired brightness and sharpness by following the instructions. Buttons EXIT Functions Exit the OSD (On-Screen Display). -- Adjust setting bars (i. e. , CONTRAST, BRIGHTNESS, etc. ) to decrease setting values of the OSD. Adjust setting bars ( i. e. , CONTRAST, BRIGHTNESS, etc. ) to increase setting values of the OSD. Green ­ Normal operation Amber ­ Power Management (i. e. , DPMS mode: reduces power consumption < 5W when receiving no horizontal and/or vertical sync signal) + Power LED light status display How to Use the OSD (On-Screen Display) The OSD (On-Screen Display) lets you easily adjust the various settings for your LCD Monitor to desired levels of performance. The OSD includes a main menu and various submenus. Operating Procedure The buttons on the upper left side of the Control Panel are used to navigate the OSD. Follow the sequence below to do the following: navigate the OSD menu item, go through the submenus, select a setting, save or cancel the setting, and finally exit the OSD item. 1. Press " " or " " to display the OSD menu. Press " " to select the main menu item. [. . . ] amber If the signal cable is properly connected. If the signal timing of the computer is within the spec. Display is too dark or too bright Display is not in the center Display is shaking If the video output level of the computer is within the specifications of the monitor. If the signal timing of the computer is within the specifications of the monitor. [. . . ]